Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 6 threaded fasteners
- 2 Ø5, length 5 spacers
- 2 brackets
Assembly
Slide the staple fixings into the slots on the inside of seat cowl.
Using the screws provided fit the brackets front and rear as shown in pictures 1&2.
Ensure that spacers are fitted on the screws as shown in photo 1
Before final tightening, position cowl on bike and centre it.
Remove and tighten all screws to brackets in final position.
Position of self-
adhesive pads
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our painting
suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
- 6 BHc 5×15 screws
- 2 self-adhesive pads
Position of front bracket.
Location of rear bracket.
« CAUTION »
FITTING INSTRUCTIONS
"SEAT COVER"
ZX6 R 2005/2006
ZX10 R 2006/2007
Position of spacers
Publicité
