Publicité
Les langues disponibles
Les langues disponibles
O P E R A T I N G I N S T R U C T I O N S
LCD-Timer with
colour change
Item-No. 67 20 08
Intended use
The device is a combination of a count-down-timer and a count-up-timer.
You can preset the duration for the count-down-timer after which a sound signal is emitted (you can also switch
on the optional visual LED-signal). Using the count-up-timer an elapsed period can be determined, in the same
way as with a stop watch.
Read the user manual carefully and fully before using the product for the first time, pay attention to all the safe-
ty instructions and information in this user manual.
This product complies with the applicable National and European regulations. All names of companies and
products are the trademarks of the respective owner. All rights reserved.
Package Contents
• Timer
• Operating Instructions
Features
• big 4-digit LC Display (minutes = display „M" and seconds = display „S")
• Count-Down- and Count-Up-Function
• Runtime up to 99 minutes and 59 seconds (1 second steps)
• Sound signal after the elapsed timer duration (optional visual alarm selectable)
• Memory function for the set timer duration
Safety Instructions
Please read all the instructions before using this device, they include important infor-
mation on its correct operation. The warranty will be void in the event of damage caused
by failure to observe these safety instructions! We do not assume any liability for any
consequential damage!
We shall not accept liability for damage to property or personal injury caused by incor-
rect handling or non-compliance with the safety instructions! The warranty will be void
in such cases.
The unauthorized conversion and/or modification of the product is inadmissible for reasons of
safety and approval (CE).
The product is not a toy and should be kept out of the reach of children. The product contains
glass (display), and swallowable small parts and batteries.
Do not carelessly leave the packaging material lying around since it could become a danger-
ous plaything for children.
The device must not be exposed to extreme temperatures, strong vibrations, high humidity or
strong mechanical stress.
Do not place the device close to monitors, TV sets, magnetic storage systems, e.g. credit cards,
cassettes, etc., since these may be deleted or damaged by the magnetic holder on the back of
the device.
The product is only intended for use in dry indoor locations.
Avoid use during unfavourable ambient conditions. Adverse ambientconditions are: Too high a
humidity (>90 % rel. humidity), damp, dust and flammable gases, vapours or solvents, ambient
temperatures that are too high (> +40°C) or ambient temperatures that are too low (< 0°C).
If you have any questions, which are not answered in this manual, please contact our technical
service or an other specialist.
Controls
1) „START/STOP/MEMORY" button
2 „MIN" button
3 „SEC" button
4 „LIGHT ON/OFF" button
5 Hinged magnetic holder
6 Sliding battery compartment cover
Inserting/replacing the batteries
Keep the batteries out of the reach of children. Do not leave batteries lying around. Children or
pets may swallow them.
Always change all of the batteries at the same time. Mixing old and new batteries may lead to
leaking of the batteries and therefore to damage to the device.
Ensure that batteries are not taken apart, short-circuited or thrown into a fire. Never use con-
ventional, non-rechargeable batteries. There is a risk of explosion!
To prevent damage to the device from leaking batteries, remove the batteries if you are not
going to use the device for a prolonged period. Leaking or damaged batteries can cause burns
if they come into contact with the skin. You should therefore wear suitable protective gloves.
Always replace the complete set of batteries. Never mix batteries and rechargeable batteries,
do not mix batteries/rechargeable batteries with different states (e.g. charged and half charged
batteries).
• Open the battery compartment on the back of the device to insert or replace the batteries. Slide the battery
compartment cover from the device in the direction of the arrow.
• Insert 3 new Micro/AAA batteries, with the correct polarity (pay attention to +/Plus and -/Minus). The correct
polarity is indicated in the battery compartment.
• Carefully close the battery compartment cover again, the cover clicks in place.
• The batteries have to be replaced when the display looses contrast or the device no longer functions.
Using the Count-Down Timer
www.conrad.com
• Set the desired duration for the count-down-timer using the buttons „MIN" (to set the minutes) and „SEC" (to
set the seconds).
Version 07/09
• To start the count-down-timer, briefly press the button „START/STOP/MEMORY" (1).
°
The timer display runs; also the display „M" (minutes) and „S" (seconds) flash.
The count-down-timer can be stopped and restarted by briefly pressing the button „START/STOP/ MEMO-
RY" (1) .
• After the timer duration (at „00:00") elapses, an audible signal is emitted for about one minute; the device
automatically changes to the count-up-timer mode. In this way you can determine how long it has been since
the set count-down duration elapsed.
• Stop the audible signal by briefly pressing the button „START/STOP/MEMORY" (1). The timer duration you
set last appears in the display (e.g. 10 minutes).
• If the count-down timer is stopped (if necessary, briefly press the button „START/STOP/MEMORY" (1)) it
can be reset to „00:00" by pressing both buttons „MIN" (2) and „SEC" (3) simultaneously.
After that another/new time can be set for the count-down timer or the the count-up timer can be used.
Using the Count-Up Timer
• If the timer is running, stop it (briefly press the button „START/STOP/MEMORY" (1)).
• Reset the timer to „00:00", by pressing both buttons „MIN" (2) and „SEC" (3) simultaneously.
• To start the count-up timer, briefly press the button „START/STOP/MEMORY" (1). Using the same button,
the count-up-timer can be stopped and restarted.
• In order to reset the count-up timer to „00:00", you must stop it first with the button „START/STOP/ MEMO-
RY" (1) and then press both buttons „MIN" (2) and „SEC" (3) simultaneously.
Illumination and visible alarm for the count-down timer
• By repeatedly pressing the button „LIGHT ON/OFF" (4), one of the available background colours can be
selected.
Hold the button „LIGHT ON/OFF" (4) pressed down for a few seconds in order to save the present back-
ground colour or to activate the optical alarm (symbol „
tivate it (symbol „
If you now press the button „LIGHT ON/OFF" (4) briefly, to activate the illumination for a few seconds, the
light colour selected will be used.
• If the symbol „
vated.
Beginning from the last 60 seconds of the timer duration for the count-down timer, the background illumi-
nation turns green, from 30 seconds it turns blue and red for the final 10 seconds. When the alarm signal is
emitted (for about 1 minute) there is an automatic colour change to indicate that the count-down duration
has elapsed.
Magnetic clamp
At the back of the timer there is a hinged magnetic holder. The timer can be attached to an appropriate sur-
face with this.
Maintenance and Cleaning
The device is maintenance-free. For this reason, you should never open it. This will void the warranty for the
device.
The outside of the housing should only be cleaned with a clean, soft, dry cloth.
Never use aggressive cleaning agents or chemical solutions, these can cause discolouring of the surface or
even malfunctions.
Disposal
a) In general
6
b) Disposal of used batteries/rechargeable batteries
5
Technical Data
Battery type: ..................................................3x AAA/Micro
Weight: ..........................................................Approx. 70g (without batteries)
Dimensions: ..................................................Ca. 80 x 40mm (Ø x H)
Max. timer duration: ......................................99 minutes, 59 seconds.
Operating ambient temperature:....................0°C to +40°C
Air humidity during operation:........................max. 90% rel. humidity, not condensing
© Copyright 2009 by Conrad Electronic SE.
For a quick adjustment, hold the corresponding button down for a while.
" disappears).
" appears at the bottom of the display, the visible alarm for the count-down timer is acti-
Keep a sufficient distance to magnetic cards, picture tubes or similar, since they can be affect-
ed or even damaged by the magnet!
Please dispose of the device when it is no longer of use, according to the current statutory
requirements.
As the end user, you are required by law (Battery Ordinance) to return all used
batteries/rechargeable batteries; disposal of them in the household waste is prohibited.
Contaminated batteries/rechargeable batteries are labelled with these symbols to indicate that
disposal in domestic waste is forbidden. The symbols for dangerous heavy metals are: Cd =
Cadmium, Hg = Mercury, Pb = Lead.
You can return used batteries/rechargeable batteries free of charge to any collecting point of
your local authority, to our stores or to any other store where batteries/rechargeable batteries
are sold.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or
the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
" appears at the bottom of the display) or to deac-
Publicité
