Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Step 3, cont'd:
• Retighten all six (6) screws you just loosened. Torque them until hand-tight.
• The Mounting Trim Strips should now wrap around the wood panel and the original outer portion of
the door.
• Close and latch the door.
:
Step 4
Attach Mounting Trim to Wood Panel
• Drill pilot holes for the Panel Mounting Screws through the four (4) holes on each side in the Mounting
Trim Strips using the
screw enters.
• Drive the Panel Mounting Screws provided with the kit through the Mounting Trim Strips into the wood
panel.
Step 5:
Adjust Springs
Note: If your wood panel weighs more than 4 lbs., you will need the heavy-duty springs provided in
this kit.
TIP: To prevent damage to the Toe Panel Assemblies, remove the four lower mounting screws using a
/
" socket screwdriver or a Phillips head screwdriver and set the panels aside while you are adjusting
1
4
the springs.
• Remove both of the Toe Panel Assemblies using a
• Visually check to make sure you have enough slack in your electrical connection, water line connection
and drain hose connection to remove the unit approximately one (1) foot.
Note: If you do not have enough slack in your connections, you will need to turn off the water
beneath the sink and disconnect any necessary connections. Refer to your Original Installation
Instructions for more information regarding the location of these connections. All electrical wiring,
grounding and plumbing should be done in accordance with national and local codes by quali-
fied individuals.
• Using a Phillips head screwdriver, remove the mounting screws from the side mounting strips
attached to the cabinet pull the unit out of the cabinet approximately one (1) foot.
prevent the dishwasher from tipping forward when the door is
Part No. 6 918172 A
/
" drill bit. Piloting the holes will help keep your wood from splitting where the
1
8
CAUTION: The top of the dishwasher should be held to
opened with the mounting screws removed.
/
" socket screwdriver or a Phillips head screwdriver.
1
4
6
DAX3000AX*/DAX3090AX*
Publicité
Table des Matières
