Maytag JETCLEAN II DAX3000AX Serie Mode D'emploi page 4

Step 1.1:
For 1 /
4
For / " Thick Wood Panels, go to Step 1.2.
3
4
• In addition to the rectangular face of
the wood panel, you will need to cut
the pieces shown in Figure 2.
Note: All pieces are
For DAX3000 Kits: Dimension B = 24
For DAX3090 Kits: Dimension B = 23
• Glue the shims you just made to the back of the
wood panel as shown in Figure 3 using Carpenter's glue
(yellow glue). With a damp rag, wipe up any excess glue
squeezed out while the glue is still wet.
• Apply gentle pressure and allow glue to dry fully before
attempting to assemble the wood panel to the door.
Drying time for the glue may be up to 24 hours. Read the
glue bottle for more complete drying time information.
After the glue has dried, it can be scraped off using a
putty knife and sanded smooth, if necessary.
Step 1.2: All Wood Panel Types.
• In order to drill the holes to attach the bezel, you will need to use the bezel as a drill guide. Place the
wood panel face down on your work surface with the top of the panel pointing at you.
• Align the bezel along the top of the wood panel, centered from left to right as it is shown in Figure 4.
The tabs of the bezel now contact the back of the wood panel.
Part No. 6 918172 A
" Wood Panels ONLY.
/ " thick.
1
2
/ "
3
4
/
11
16
"
Figure 2 – Shim Dimensions
/ " thick
1
4
FIGURE 3 – Shim Placement Pattern
3 DAX3000AX*/DAX3090AX*