Uniteck UNISUN M Serie Mode D'emploi page 27

CONNECTION
To proceed to connection, please observe the following order:
CONNECTION ORDER
DISCONNECTION ORDER
To proceed to disconnection, please observe the reverse order:
Never connect the panels to the regulator before connecting the batteries.
Never disconnect the batteries before having first disconnected the panels.
Not complying to this order may disturb the regulator charge voltage. For more information, please refer
to your photovoltaic charge regulator user manual.
CONNECTION FOR PANELS WITHOUT CABLES
In order to connect the cables to your panel, please follow these instructions:
1/ Open the junction box in the back of your panel
2/ Pass your cables through the cable glands
3/ Connect your cables to the junction box terminals
4/ Close the junction box and screw the cable glands
Note: We recommend to identify your cables polarity with labels in
order not to make any mistake when connecting your panel to your
solar charge controller
1
 Connection regulator ➔ battery
 Connection panel ➔ regulator

Disconnection panel ➔ regulator
 Disconnection regulator ➔ battery
www.uniteck.fr
EN
27/59