Connection With The Mains; Operation; Stand Alone Operation; Dmx-Controlled Operation - Futurelight DJ-SCAN 250 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the DJ-SCAN 250 starts running. During the Reset, the motors
are trimmed and the device is ready for use afterwards.
Turn the objective-lens for adjusting the focus in order to obtain a sharp projection.

Stand Alone operation

In the Stand Alone mode, the DJ-SCAN 250 can be used without controller. You can do without a controller
as the DJ-SCAN 250 features a built-in microphone, which provides automatic sound control.
Disconnect the DJ-SCAN 250 from the controller and select "Master Mode: Sound-control".
If you have connected a footswitch to the Blackout-socket, you can lock the light output (Blackout-mode) and
turn it on again.
Master/Slave-operation
Connect the master and slave-devices and adjust the settings as desribed above.
Please note: If you wish to change from one operating mode into another, you have to unplug the projector
from the mains and plug it again.

DMX-controlled operation

You can control the projectors individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. In order to call up the different features, you first have to open the shutter
(control channel 6, DMX-value 132-139 or 250-255) or set the dimmer to the desired intensity (control
channel 6, DMX-value 6-128).

Addressing

The Control Board on the front side of the base allows you to assign the DMX fixture address, which is
defined as the first channel from which the DJ-SCAN 250 will respond to the controller.
If you set, for example, the address to channel 7, the DJ-SCAN 250 will use the channel 7 to 14 for control.
Please, be sure that you don't have any overlapping channels in order to control each DJ-SCAN 250
correctly and independently from any other fixture on the DMX data link.
If two, three or more DJ-SCAN 250 are addressed similarly, they will work similarly.
For address setting, press the Mode-button until the display shows "d" and set the desired address via the
Up/Down-buttons.
Controlling:
After having addressed all DJ-SCAN 250, you may now start operating these via your lighting controller.
International
L
N
25/52
51839250X62NXS_V_1_0.DOC

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dj-scan 200

Table des Matières