Parts Of The Device - EDM Product 07596 Mode D'emploi

07596
REF.

PARTS OF THE DEVICE

OPERATING INSTRUCTIONS
Be very careful when using a professional hair straightener. This iron
reaches a temperature of 200 ºC to prevent damage to the hair, be sure
to use the correct temperature setting according to your hair type.
1. Connect the appliance to the mains and then press button "1" until
the LED display lights up
2. Press button "1" to adjust the desired temperature: 200 ºC - 180 ºC -
160 ºC - 140 ºC - Off
During the warm-up time, the temperature display will be activated
until the desired temperature is reached.
When the iron reaches the desired temperature, the thermostat will
stop and the temperature will be displayed.
3. Shutdown: Click the "1" button until the LED display turns off, then
disconnect the appliance from the mains.
AUTOMATIC SAFETY DISCONNECTION
After about an hour, the hair straightener will automatically turn off. To
reactivate the iron, press the ON / OFF switch.
USE THE IRON
- Separate your hair into strands of approximately 8-9 cm. wide and
carefully comb them.
- Then put the strand separated between the hot plates and close the
iron.
- Keep it closed on the strand of hair for a few seconds, depending on
the type of hair.
- The best results are obtained if you start at the hair root and continue
progressively and continuously to the ends of the lock.
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
On / off switch and temperature
control button
Floating ceramic cladding plates
INSTRUCCIONES IMPORTANTES DE SEGURIDAD
360 ° swivel cord