Design Features - Rockford Fosgate PUNCH Element Ready PMX-0 Mode D'emploi

Design Features

Rotary Encoder
This knob is for adjusting the main volume.
Power button
Pressing this button will power the unit ON and OFF.
SRC (Power) Button
Pressing this button allows you to switch
between input sources.
SUB Buttons
Pressing these buttons allow you to adjust the
subwoofer output UP or DOWN (0-12).
Mounting
To mount the unit, you will need to find a flat surface with adequate
clearance behind that provides enough clearance for the unit and all it's
necessary wiring.
1. Once you have determined a mounting location, you will need to cut
a circular hole 2" (52mm) in diameter.
2. After the hole is cut slide the unit and wiring into through the hole.
3. Take the U bracket and slide over the two studs on the back of the
unit. Tighten down with supplied nuts.
4. Press on the trim bezel on the front side of the unit.
5. Plug in all wiring harnesses and cables. Refer to the wiring diagram
for wire harness connection types.
PMX-0
Autogoods "130"
REV / FWD button
Use these buttons to skip back and forward
through channels or tracks with a short press.
DIMMER button
Pressing this button will allow you to select
between the two brightness values for the display.
PLAY / PAUSE button
Press this button to play or pause your music. This
button also acts as a MUTE when the source is in
AUX mode.
Source Unit
4
Fig. 1
Nuts
Bracket
Panel
Fig. 2