Utilitech PHB-1500 Mode D'emploi page 5

ASSEMBLY INSTRUCTIONS - FREESTANDING
5. Remove the two middle pre-assembled screws from the back of the heater (C) by phillips
screwdriver (not included). Attach the heater to the connecting tube (B) using these two screws by
phillips screwdriver (not included).
5
After assembly, the product should appear like this:
FRONT
BACK
Lowes.com
8
ASSEMBLY INSTRUCTIONS - WALL-MOUNTED
1. Remove the four pre-assembled screws from the back of heater (C), then attach the handle (I) and
the wall mount (J) to the heater (C) using these four screws.
Hardware Used
1
2. Select a mounting location. Drill two holes in the wall (refer to inset image below) 28 mm apart.
Insert the two diameter 8mm wall anchors (CC) into the pre-drilled holes. Using the two ST4x35
screws (BB), to fix the two side holes in wall mount (J) to secure the wall mount (J) to the wall
anchors.
NOTE: There is no need to insert a screw into the middle hole to secure the unit.
Hardware Used
Diameter 8 Wall Anchors
CC
ST4x35 Screws
BB
2
x2
x2
Lowes.com
9