Franke FGB 906 W AC Mode D'emploi Et Installation page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

• Before hooking up the hood body, lock the 2 screws Vr located
on the hood body connection points.
• Hook the hood body to the screws 12a.
• Finish tightening the support screws 12a.
• Turn screws Vr to level the hood body.
• If necessary the hood can be fastened to the wall using other
screws and plugs, which can be inserted from the inside of the
hood canopy (see paragraph on Maintenance for how to dis-
mantle the Comfort Panel and Filters).
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the
chimney using either a flexible or rigid pipe ø 150 or 120 mm,
the choice of which is left to the installer.
• To install a ø 120 mm air exhaust connection, insert the re-
ducer flange 9 on the hood body outlet.
• Fix the pipe in position using sufficient pipe clamps (not sup-
plied).
• Remove any activated charcoal filters.
RECIRCULATION VERSION AIR OUTLET
• Insert the connection extension pieces laterally 14.1 in connec-
tion 15.
• Insert the Connector 15 into the Support bracket 7.3 and fix it
with a screw.
• Make sure that the outlet of the extension pieces 14.1 is hori-
zontally and vertically aligned with the chimney outlets.
• Connect the air outlet connection 15 to the hood body outlet
using either a flexible or rigid pipe ø 150 mm, the choice of
which is left to the installer.
• Ensure that the activated charcoal filters have been inserted.
EN
Fitting the hood body
Connections
Vr
12a
ø 150
ø 120
9
14.1
7.3
15
ø 150
6 6

Publicité

Table des Matières
loading

Table des Matières