Replacing The Fuse; Technical Specifications - TechGrow T-2 PRO Manuel

To type of setting:
By rotating the PTB you scroll on to the four
windows:
CO2-SET 850 +- 40
TMP-SET 29 +- 2
RH -SET 65 +- 3
Push=Exit
CO2-MIN 583 ppm
TMP-MIN 26 C
RH -MIN 50 %
Push=Exit
CO2-MAX 1233ppm
TMP-MAX 32C
CO2-MAX 69%
Push=Exit
BOX perc. 20%
BOX A/M Auto
Auto Max 90%
Push=Exit
To type of sensor:
By rotating the PTB you scroll on to the four
windows:
CO2 SET 700ppm
CO2 +/- 50ppm
CO2 ALARM 1400ppm
Push=Exit
TMP SET 28.0 C
TMP +/- 2.0 C
TMP Corr. 0.0 C
Push=Exit

TECHNICAL SPECIFICATIONS:

Power supply:
Consumption:
Maximum capacity fan:
Maximum capaciteit CO2 source: 6A
Maximum total capacity:
Adjustment range: CO2 set:
Adjustment range CO2 +/-:
Adjustment range TMP:
Adjustment range TMP +/-:
Adjustment range RH set:
Adjustment range RH +/-:
Measurement frequency:
RH SET
RH +/-
BOX perc. 20%
BOX A/M
Auto Max
By pushing the PTB you will return to the main
menu.

Replacing the fuse:

If a short circuit occurs by overload of one of the
outlets, the fuse will blow.
These fuses have been placed at the bottom of
the controller, right of each socket.
By pressing the fuse holder slightly with a
screwdriver and turning it counter-clockwise a
quarter turn, the fuse holder can be removed.
Place a new fuse with similar specifi cations in the
fuse holder and put the fuse holder back into the
casing.
Then press the fuse back in slightly, and tighten it
again with a clockwise quarter turn.
Two new (diff erent!) fuses are provided, one for
each exit. Make sure you use the right
fuse for replacement. Damage caused by using
the wrong fuse is not covered by the
manufacturer's guarantee.
100 to 240 Volt
3 Watt (with sensor, without fan)
7A / 1700W (up to 5.000 m3/uur)
14A / 3400W (up to 10.000 m3/uur)
16A
300 to 2000 ppm
10 to 200 ppm (advice 50 ppm)
10.0 to 45.0 C.
0.0 to 5.0 C.
0 to 100 % RH
10 to 100 % RH
1 measurement per second
50%
3%
Push=Exit
Auto
90%
Push=Exit