TechGrow T-2 PRO Manuel page 12

Operating and adjusting the T-2 Pro:
All settings are done with the Push & Turn Button
(PTB). By pushing the button you will enter the
set-up menu. An arrow will appear on the left side
of the display =>.
When activating the T-2 Pro the following will
appear on the display:
TechGrow
T-2
Pro-Series
Software v. 1.x
The Brand menu is shown after a few seconds:
=> Custom
Lemmens
Torin
Push or wait 3 sec
If you do not use the PTB for a few seconds, the
controller will automatically proceed to the
calibration menu:
CO2 calibration
Continue?
Yes
=> No
After another few seconds the setup menu is
shown again:
=> TMP = 25.5 C
RH = 32 %
BOX =
CO2 = 539 ppm
You can read more about these menus further on
in the manual.
Setting the fan/box:
• Remove the plug of your T-2 Pro from the
outlet.
• Wait 10 seconds.
• Re-plug back into the outlet.
By rotating the PTB the desired fan can be
selected. Confi rm your selection with a push on
the PTB.
You will enter the Fan menu automatically
(see further in this manual).
If you are using another brand than Lemmens or
Torin, please choose Custom and push the PTB.
To return to the main menu, the T-2 Pro has to be
switched off for at least 10 seconds.
Then, switch back on.
Custom-menu:
Adjust Box to 10%
and push button
Please see manual.
• • •
The fan is now switched off .
Slowly turn the PTB until the fan has reached 10%
of its maximum speed (according to your sense).
Push the PTB and the following will appear:
Adjust Box to 90%
and push button
Please see manual.
• • • • • • • •
The fan is now rotating slowly. Turn the PTB
slowly until the fan´s speed is no longer
increasing.
This is the full 100% speed. Now turn the PTB
back to 90% (according to your sense).
Push the PTB and the following will appear:
The box is now
adjusted.
Fan reaction speed
Next: "Set the time between changing the power
level of the box"
(between 3 and 30 seconds).
Set the time between
changing the power
level of de box.
5s
If you push the PTB again you will enter the
calibration menu.
When you are using a Torin or
Lemmens fan:
Custom
=> Lemmens
=> Torin
Push or wait 3 sec
Select your brand, then select your fan:
Select fan
1000-5000 m3
Push or wait 3 sec
By rotating the PTB the desired fan can be
selected.
After a push on the button the selected fan will be
set as standard.