General Description; Functions - Gewiss Chorus GW 90 835 Mode D'emploi

GENERAL DESCRIPTION

Briefly
The Easy 4-channel 10 A actuator – DIN rail mounting allows up to 4 different electrical
loads to be activated/deactivated separately by means of 4 x 10 A relays, each one fitted
with 1 NO output contact. The switchover command of the relay can arrive from command
devices or sensors of the Home Automation system, via the KNX BUS, or be locally
generated by the front push-buttons.
The actuator is powered from the BUS line and has 4 front green LEDs for signalling the
output status. The device sends information to the bus about the relay status (ON =
contact closed, OFF = contact open) when switching on, receiving a command and in
the case of a command from a local push-button.
Each output channel of the actuator can be configured separately and allows the ON/OFF
command of the controlled loads, execution of timed commands, scene management
and execution of priority commands to force the output status. The operating modes can
be used simultaneously.
This means, for instance, that the device can switch a light on and off, or automatically
switch it on and off after a certain pre-established time, simply on the basis of the
command received.
The module is assembled on the DIN rail, inside the electric boards or junction boxes.

Functions

Each channel of the actuator can be configured with the Easy controller to carry out the
following functions:
LOAD ACTIVATION AND DEACTIVATION
The actuator channel activates or deactivates the electrical load when it receives the
ON/OFF commands sent, for example, from a contact interface or from a push-button
panel configured as Cyclic ON/OFF switchover or Fronts management.
The green LED turns on when the relay contact is closed.
EXECUTION OF TIMED COMMANDS
The actuator activates the electrical load connected for a time set with the Switch-on time
parameter, deactivating it when this time is up. This is the setting, for instance, for the
stairs light. If, during the activation period, the actuator receives a new ON command
with timer , time starts again from the beginning.
18