Espressions EM-1020 Mode D'emploi page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
Important
Do not use the 2 cup filter with paper pods.
Since the shape of the paper pods can differ from one brand to another, take care to center the pod in
the filter and push gently so that the sides fit.
IMPORTANT
If necessary, fold the sides of the paper pod inside the filter to prevent it from overhanging. This
will ensure that coffee will not leak outside the filter holder and prevent any damage.
C. Espresso function
Preparing the machine
Check the water level in the tank and fill if necessary. (fig.1) .
Check that the rotating control button is set to PENDING (
SELECTION button (h3) is at ESPRESSO/HOT WATER
Switch the machine on by turning the START/STOP button (h5) to the (I) setting.
The TEMPERATURE light (h4) flashes.
IMPORTANT
While the TEMPERATURE light (h4) flashes, none of the machine's functions can be used.
Insert the filter holder into the group head by aligning the handle with the marking "INSERTION" and
lock by moving the filter holder from left to right (fig.6) .
Firmly lock the filter holder into place and make sure it is properly inserted by pushing it to the right as
far as it will go.
Place 1 or 2 cups (as necessary) on the cup rest grill and check that it/they are correctly positioned
under the filter holder's dispensing spout, using the cup positioning marks (fig.7) .
Coffee preparation
Wait until the TEMPERATURE light (h4) stops flashing, therefore indicating that the appliance has
reached the optimum temperature for making an espresso coffee. Your appliance is now ready for use.
Push briefly espresso button
operates briefly to pre-wet the ground coffee and then stops for a few seconds and starts again to
dispense the coffee.
IMPORTANT
This pre-wetting process ensures even greater release of the aromas.
When the volume of coffee has been reached, the appliance stops automatically.
IMPORTANT
By default, the volume of coffee for "1 cup" is 50 ml; for "2 cups" it is 100 ml.
Wait a few seconds until the surplus of water in the thermo block has been drained (until the "suction
noise" has stopped).
NOTE
A little steam may be released from the water tank. This is completely normal.
Remove the cup(s) then unlock the filter holder by turning it from right to left until it can be released
from the Group head.
Drink the espresso immediately, so that its aromas and thick cream can be enjoyed to the full.
14
or
to the right to activate the
) and that the TEMPERATURE
.
ESPRESSO function. The pump

Publicité

Table des Matières
loading

Table des Matières