Installation - Nelson SmartZone EZ 8504 Guide D'installation Et De Programmation

INSTALLATION INSTRUCTIONS
NOTE: Instructions are for indoor or outdoor use.
Find a location near a 110V (220V for 8574, 8576, 8578, and 8582 models) outlet or a 110V wiring
source. Install the SmartZone EZ near eye level if possible. Open the face panel by
TM
loosening the panel locking screw and pulling the tab on the right of the front panel to swing the
panel open on its hinges. Use the three holes in the case to mark and pre-drill pilot holes in the
wall. The left two hole guides in the SmartZone TM EZ are vertically aligned for mounting the
controller to a stud. (See Figure 1) Insert screws through the holes in the case and screw each
into the corresponding pilot hole in the wall.
NOTE: The front panel can be removed to aid in installation by removing the ribbon
connector from the interconnect board and pulling the front panel off its hinges.
FIGURE 1
4.375"
6.875"
4