Front Panel Layout - Nelson SmartZone EZ 8504 Guide D'installation Et De Programmation

PROGRAMMING INSTRUCTIONS

Front Panel Layout

Looking at the front panel (see figure 4), you see a large LCD, 4 rubber buttons, one large rotary
dial, and two small rotary dials. The rubber buttons are marked "SELECT" and "ADJUST" and are
the heart of Nelson's exclusive
with for increasing or decreasing the segment you're working on.
SELECT&ADJUST™ works on the principle that you first SELECT what you want to set, and
ADJUST the variables of what you selected. For example, if you want a run time of 10 minutes
on zone 5, you would use the SELECT
would use the ADJUST
There are instances when only SELECT or only ADJUST is required. They will be explained in
this guide where appropriate. A Rule of Thumb: SELECT will select zones or a particular
start time (1,2 or 3). ADJUST will adjust Times, Dates, and % Water Budget. See the hang
card inside the lid of the SmartZone
different dial positions.
SELECT&ADJUST™ programming. The keys are identified
keys to select zone 5 and, once on zone 5, you
keys to set the run time to 10 minutes.
EZ for a quick reference on what buttons to use for
TM
11