Amtra biopond STREAM Mode D'emploi page 7

the type of configuration necessary for your needs: direct suction from the cover / grid or from a tube. In this second case, connect the scalar hose con-
nector to both the inlet and outlet of the water, proceeding as shown in (FIG.2). MAINTENANCE: When you notice a reduction in the flow of water you
need to turn off the pump, remove it from the water after having previously turned off all other appliances in the water (pond / fountain / aquarium),
remove the pump and clean the cover / grille and impeller. The impeller must be carefully extracted from its housing and rinsed under running water
to remove residues of dirt or encrustations (in case of particularly persistent limescale deposits, it is recommended to leave the impeller in the vinegar
for 24h in a bath.In this case rinse thoroughly under water current before reassembling it). It is advisable to repeat this operation at least once a month.
Once cleaned, carefully reassemble each piece, reposition the pump according to the installation procedures and restart the appliance.
WINTER RECOVERY: If the appliance is exposed to the risk of freezing, in order to prevent breakage it is advisable not to use it during the winter period
and store it thoroughly clean in a place that is not subject to freezing. WARRANTY: This product is guaranteed for a period of 24 months, from date of
purchase, against defects in materials or workmanship. The guarantee certificate must be completed in its entirety by the dealer and must accompany
the product in the event that it is returned for repair. The warranty consists in the replacement of defective parts. This warranty does not apply in case
of improper use, nor liable for damage caused by tampering or negligence by the purchaser. For warranty service, return the device together with the
purchase receipt or equivalent, with a detailed description of the problem. Excluded from warranty are all parts subject to wear and tear.
• The manufacturing company assumes the commitment to replace at its discretion the malfunctioning or incorrect manufacturing parts, only after
careful quality control and detection of poor construction.
• Always charged to the buyer are the cost of transport and / or delivery in case of misuse of warranty terms
• During the warranty period, replaced products become property of the manufacturer.
• Of this guarantee can only benefit the original purchaser who has complied with the normal maintenance instructions in the manual. Our liability on
the guarantee expires when: the original owner sells the product properties, or when changes were made to the same.
• The product that is part of the defective product must be delivered to the manufacturing company for replacement; otherwise, the replaced part will
be charged to the purchaser. FAILURE TO OBSERVE THE MODES OF INTERVENTION AND THE USE OF LIGHTING EQUIPMENT FOR AQUARIUMS DESCRIBED IN
THIS DOCUMENTATION (INSTRUCTION AND MAINTENANCE MANUAL AND ATTACHED MANUALS) ENTAILS THE DECAY OF THE WARRANTY TERMS. If even
small parts break, replace the product. If parts of the product are swallowed, contact your vet. RECYCLING: The appliance is marked with the appro-
priate symbol which indicates that the product must not be disposed of with other household waste at the end of its life cycle, but through separate
separate collection of electrical and electronic equipment. To avoid damage to the environment or to health caused by inadequate waste disposal,
the purchaser is invited to separate this appliance from other types of waste and recycle it responsibly to facilitate the re-use of material resources.
Domestic users will be able to return the appliance to the retailer when buying a new one-to-one equivalent appliance, or contact the local office in
charge for all the information regarding recycling and recycling for this type of product. Business users must not dispose of this appliance together
with commercial waste, but through a separate collection system compatible with the European directive 2002/96 / EC.
Disposal that does not comply with current regulations is punished with administrative penalties as per current legislation.
FIG.1
FIG.2
ISTR_STREAM.indd 7
STREAM
1. Fixing ring nut
2. O-ring
3. Hose connection
4. Connector
5. O-ring
6. Impeller chamber
7. Impeller
8. O-ring
9. Ceramic bearing
10. Bearing seat
11. Engine
12. Cap
13. Handle
14. Cover / top grid
15. Engine support
16. Deflector
17. Lower cover
gb
04/01/19 16:38