Table des Matières
Publicité
FCC COMPLIANCE STATEMENT: This device complies with FCC Rules Part 15. Operation is subject to the following
two conditions: 1) This device may not cause interference, and 2) this device must accept any interference that may be
received, including interference that may cause undesired operation. The manufacturer is not responsible for any radio or
lV interference caused by unauthorized modification to this equipment. Such modification could void the user's authority
to operate the equipment.
FCC WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against hannful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause ham,ful inerference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet different from that to which the receiver is connected.
•
Consult the dealer or an experienced radionv technician for help.
Caution: To comply with the limits for an FCC Class B computing device, always use the shielded signal cord supplied with this unit.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.
Scosche Industries Inc. warrants this product to be free from defects in material and workmanship for a period of 1 year
from purchase. This Scosche product is sold with the understanding that the purchaser has independently determined
the suitability of this product. This warranty is offered to the original purchaser of the product only. This warranty does
not cover the product if physically damaged, subject to negligence or misuse, abuse, alteration, accident, or an act of
GOD. This warranty does not apply to product which has water or physically damaged by accident or which has been
misused, disassembled or altered.
The original dated sales slip or proof of purchase will establish warranty eligibility. If the product should prove defective
within the warranty period, return the product with proof of purchase to Scosche Industries Inc. Scosche, at its option,
will replace or repair the product free of charge and return the product postage paid.
In no event shall Scosche Industries, Inc. be responsible for claims beyond the replacement value of the defective
product, or in any way be liable or responsible for consequential or incidental damages. No empress warranties and no
implied warranties, for any particular use or otherwise, except as set forth above (which is made expressly in lieu of all
other warranties) shall apply to products sold by Scosche.
Cet appareil est conforme aux normes RSS ne necessitant pas de licence d'lndustrie Canada. Le fonctionnement est
sujet aux deux conditions suivantes : (1) cet appareil ne doit pas causer d'interference, et (2) cet appareil doit pouvoir
accepter toute interference rer;ue, incluant /'interference qui peut engendrer un fonctionnement non desire de l'appareil.
En vertu des re!]fementations d'fndustrie Canada, cet emetteur radio ne peut fonctionner qu'en utilisant une antenne d'un
type et d'un maximum (ou moindre) de gain approuve pour /'8metteur par lndustrie Canada. Pour reduire /es eventuelfes
a
interferences radio
d'autres utilisateurs, le type d'antenne et son gain devraient �tre choisis de maniere
puissance isotrope rayonnee equiva/ente ne soit pas plus que ce qui est necessaire pour une communication reussie.
IC: 6955A-RH1060
FCC AUTHORIZATION
FCC ID: IKQRH1060
IC NOTE
IC: 6955A-RH1060
LIMITED WARRANTY
REMARQUE IC
10
a
ce que la
Publicité
Table des Matières
