Installing The Wall Mounting Bracket; Appliance Installation; Removing The Appliance; Electrical Connection - Elcalor SH 2020 Utilisation Et Installation

Installation

10.2 Installing the wall mounting bracket

The appliance is intended for wall mounting using the wall
mounting bracket supplied.
Note
◦ The wall mounting bracket can be used as a
template for wall mounting. This ensures suffi-
cient clearance from the floor.
◦ Use a spirit level if the floor is uneven or slop-
ing.
1
a a a
≥183
» Unhook the wall mounting bracket from the
appliance.
» Place the centred wall mounting bracket horizontally
on the floor. Mark holes 1 and 2.
» Lift up the wall mounting bracket so that its lower
holes match up with the markings you have just
made on the installation wall.
» Mark holes 3 and 4 on the installation wall.
» Drill the holes at the 4 markings.
» Secure the wall mounting bracket with suitable fixing
materials (screws, rawl plugs). With the vertical slots,
you can compensate for an offset fixing hole.
42
3
2
≥183

10.3 Appliance installation

4
1 Wall mounting bracket
» Hook the appliance onto the bottom tabs of the wall
mounting bracket by the slots in the back of the
appliance.
» Place the appliance in an upright position.
» Secure the appliance by pushing it towards the wall
until it audibly snaps into place in the two upper
springs on the wall mounting bracket.
1
1 Appliance
2 Locking screw
» Secure the appliance against unintentional release
using the supplied locking screw on the right or left-
hand side of the wall mounting bracket.

10.4 Removing the appliance

» Undo and remove the locking screw from the wall
mounting bracket.
» To release the appliance, push down the springs at
the top of the wall mounting bracket.
» Tilt the appliance away from the wall and lift it off the
bottom tabs on the wall mounting bracket.

10.5 Electrical connection

WARNING Electrocution
◦ Carry out all electrical connection and instal-
lation work in accordance with relevant regula-
tions.
◦ Do not install the appliance with a fixed power
cable.
Material losses
◦ Observe the type plate. The specified voltage
must match the mains voltage.
◦ Ensure the on-site supply cable has an ade-
quate cross-section.
The appliance is supplied fully wired (with a mains plug),
but it is also suitable for permanent connection.
1
2