Parts List - Paramount PP730 Mode D'emploi

Before you begin, make sure all parts shown are included with your product.
Parts may appear slightly different than illustrated.

Parts List

Description
AA wall arm assembly
M4 x 12 mm phillips screw
A
B M4 x 20 mm phillips screw
retaining spacer
C
#14 x 2.5" wood screws
D
E 5 mm allen wrench
concrete anchors
F
G cable ties
3/16" allen wrench
I
B
A
C
D
Installation to Wood Stud Wall
WARNING
• Make sure that the supporting surface will safely support
the combined load of the equipment and all attached
hardware and components.
Using a stud finder, locate and mark the edges of the
1
wood stud used in mounting this product. Use of an
edge to edge stud finder is highly recommended. Use a
level to draw a vertical line down the center of the stud.
Use wall plate as template to mark center of holes
along the vertical line. Drill two 5/32" (4 mm) dia. holes
2.5" (65 mm) deep. Attach wall arm assembly (AA) to
wall using two #14 x 2.5" flat head wood screws (D) as
shown in figure 1.1.
Skip to step 2 on page 4.
WARNING
• Tighten screws so that wall plate is firmly attached, but
do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the
center of the studs. The use of an "edge to edge" stud
finder is highly recommended.
PP730 PP730-S
Qty. Part # Part #
1 095-0488-GB 095-0488-SS
4 504-9013 504-2013
4 504-9020 504-2014
4 590-5005 590-5003
2 520-1202 520-2165
1 560-9640 560-9640
2 590-0097 590-0097
2 560-1725 560-2007
1 560-0071 560-0071
E
F
G
AA
I
WOOD STUD
WALL
D
fig. 1.1
AA