Conrad 59 50 48 Mode D'emploi page 3

O P E R A T I N G I N S T R U C T I O N S
HDMI Radio Transmission Set
1080p
Item no. 59 50 48
Intended use
This product enables the wireless transmission of HDMI-compatible digital AV signals via radio from a play-
back device (e.g. DVD or Blue-ray player) to a receiver (e.g. television or monitor).
Radio transmission of the IR control signal from an IR remote control is also possible, so the location of the
playback device can be chosen freely.
The power is supplied via two enclosed wall plug transformers.
Always observe the safety instructions and all other information included in these operating instructions.
Any use other than that described above could lead to damage to this product and involves the risk of short
circuits, fi re, electric shock, etc.
This product complies with the applicable national and European requirements. All names of companies and
products are the trademarks of the respective owners. All rights reserved.
HDMI is a registered trademark of HDMI Licensing L.L.C.
Package contents
• Transmitter unit ("Transmitter")
• Receiver unit ("Receiver")
• 2 Wall plug transformers
• IR transmitter (for connection to the transmitter unit)
• HDMI-compatible connection cable
• IR remote control
• 2 batteries of type AAA/Micro
• Operating instructions
Explanation of Symbols, Inscriptions
A triangle containing a lightning symbol indicates a health hazard e.g. electric shock.
This symbol indicates specifi c risks associated with handling, function and use.
The "Hand" symbol indicates special tips and operating information.
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe these safety
instructions! We do not assume any liability for any resulting damage!
We shall not accept liability for damage to property or personal injury caused by incorrect
handling or non-compliance with the safety instructions! In such cases, the warranty will
be null and void.
• The unauthorised conversion and/or modifi cation of the product is not permitted for safety and
approval reasons (CE).
• The product is not a toy. Devices operated using mains voltage do not belong in the hands of
children. Therefore, be especially careful when children are around.
Use the product where it is out of the reach of children.
• The product is intended for use only in dry, indoor locations. No part of the product should
become damp or wet; never handle it if your hands are wet!
With the wall plug transformers there is also the deadly peril of an electric shock!
• Do not disconnect the wall plug transformers from the mains socket by pulling the cable. Take
hold of it on the sides of the housing and pull it out of the mains socket.
• If the wall plug transformer is damaged, do not touch it; there is danger to life from electric
shock!
Switch off all the poles of the mains socket to which the wall plug transformer is connected
(switch off at the corresponding circuit breaker or remove the safety fuse, then switch off the
earth leakage circuit breaker). Unplug the wall plug transformer from the mains socket.
Replace the defective wall plug transformer only with a wall plug transformer of the same
design.
• The design of the wall plug transformers complies with Protection Class II. Only use a stand-
ard mains socket as the voltage source for the wall plug transformers (see section "Technical
Data").
The mains socket into which the wall plug transformers are plugged must be easily accessible.
• Do not leave packaging material carelessly lying around, since it could become a dangerous
plaything for children.
• Handle the product with care; it can be damaged by impacts, blows, or accidental falls, even
from a low height.
General information on batteries/rechargeable batteries
www.conrad.com
• Batteries/rechargeable batteries must be kept out of the reach of children.
• Check that the polarity is correct when inserting the batteries/rechargeable batteries (pay attention to
plus/+ and minus/-).
Version 07/13
• Do not leave batteries/rechargeable batteries lying around; there is a risk that they could be swallowed by
children or pets. If they are swallowed, consult a doctor immediately.
• Leaking or damaged normal/rechargeable batteries in contact with the skin can cause acid burns; there-
fore, use suitable safety gloves.
Liquids leaking from batteries/rechargeable batteries are very chemically aggressive. Objects or surfaces
coming into contact with these liquids might be considerably damaged. Thus, store batteries/rechargeable
batteries in a suitable location.
• Ensure that batteries/rechargeable batteries are not short-circuited or thrown into a fi re. There is a risk of
explosion!
• Do not recharge normal, non-rechargeable batteries. There is a risk of explosion! Charge only recharge-
able batteries that are intended for this purpose; use a suitable battery charger.
• If the product is not to be used for a while (e.g. storage), remove the batteries/rechargeable batteries. Old
batteries/rechargeable batteries can leak and cause damages to the product; loss of guarantee/warranty!
• Always exchange the whole set of batteries/rechargeable batteries, only use batteries/rechargeable bat-
teries of the same type, by the same manufacturer and in the same charging state (do not mix charged
batteries with half-charged or fl at batteries/rechargeable batteries).
• Never mix normal batteries with rechargeable batteries. Use either batteries or rechargeable batteries.
• For the environmentally friendly disposal of batteries and rechargeable batteries, please read the chapter
"Disposal".
Controls
a) Transmitter unit ("Transmitter")
1
2
3
4
5
6
7
8
9
b) Receiver unit ("Receiver")
10 On/off switch with integrated LED
11 "SOURCE" key to toggle the input
12 LEDs to indicate the selected input
13 IR receiver
14 Mini USB socket for power supply, for the connection
15 HDMI output, for connection to the TV set/monitor
Connection
Do not place the transmitter and receiver unit on the surface of valuable furniture, without appropriate and
suffi cient protection, as this may cause scratches or dents.
a) Transmission unit ("Transmitter")
• The transmission unit features two HDMI inputs (6 and 7). Connect them to the HDMI output of the play-
back devices, e.g. the HDMI output of a Blue-ray player and a game console.
• The input selected accordingly is looped through at the HDMI output (8) of the transmission unit. Here, you
can connect a TV set or monitor (if required).
• If you want to use the enclosed IR transmitter, plug the TRS connector into the corresponding socket (4)
on the transmitter unit.
• Place the IR transmitter in front of the IR receiver of your playback device (e.g. Blue-ray player). The
correct position is normally marked (e.g. with the inscription "IR"). In case of doubt, follow the "playback
device" operating instructions for where the IR receiver is installed.
LEDs to indicate the selected input
"SOURCE" key to toggle the input
On/off switch with integrated LED
TRS socket for the connection to the
IR transmission module
Low-voltage socket for the power supply,
for the connection of the wall plug
transformer provided
HDMI input 1
HDMI input 2
HDMI output (to loop through the selected
input 1 or 2)
Service port, only for the manufacturer,
do not connect anything!
of the wall plug transformer provided
Both transmitter and receiver can be hung up via corresponding openings on the bottom side
and fastened on two screws. Alternatively, there is a stable tripod socket on the bottom side.
First switch off all devices, to which you will connect the radio transmission set.
1 2 3
4
5 6 7 8 9
14 15
10
11
12
13