Using Boost Mode - JVD Shield Mode D'emploi

USING BOOST MODE

BOOST mode is a shock purification mode.
Its purpose is to treat potent nuisance sources
in a short time (one-off unpleasant odours,
pollution, contamination and allergens) and
At the end of the BOOST cycle, the appliance will automatically switch back to the previous mode.
Changing the area
Stopping BOOST
We recommend activating BOOST mode no more than three times an hour. More frequent use will
reduce your appliance's lifespan.
Stopping
CONTINUOUS
mode
BOOST PURIFICATION DURATION
Activating
the mode
being purified
Switching to
CONTINUOUS
mode
mode
Press HOME. This takes you back to
the HOME screen. The purification
cycle will stop. The Shield will then
await further instructions.
Click on CONTINUOUS again. The
purification cycle will stop. The Shield
will then await further instructions.
the mode shows on the screen as a quick
glow/fade.
JVD ® 's patented Shield technology adapts
to the size of your room.
BOOST
10 mins
15 mins
20 mins
Press BOOST to start a shock
purification cycle. The Shield will start
performing the purification cycle.
You cannot change a purification area
during BOOST mode. If you do wish
to change the purification area, press
HOME to return to the HOME screen.
Select the new purification area, then
restart the BOOST mode.
Press CONTINUOUS.
Refer to the CONTINUOUS section
of these instructions for information
about this mode.
Press HOME. This takes you back to
the HOME screen. The purification
cycle will stop. The Shield will then
await further instructions.
Press BOOST again. The purification
cycle will stop. The Shield will then
await further instructions.
19