Troubleshooting Guide; Humidificador De Aire - VISIOMED BABY humidoo XL VM-H2 Notice D'utilisation

VII. TROUBLESHOOTING GUIDE
Refer to the table below if the appliance operates abnormally :
SYMPTOMS POSSIBLE CAUSES
Does not switch on quickly Is there enough water in
the reserve ?
Is the power cable connected
properly ?
No mist or abnormal mist Not enough water ?
Too much water ?
Membrane fouled by
scale ?
Are the cover and the
inside cover badly placed ?
Is the air intake hole under
the base fouled ?
Water leakage from the Are the cover and the
appliance inside cover badly placed ?
Has the appliance been
tipped over ?
Low temperature or high
humidity ?
20
SOLUTIONS
Add water to the tank.
Disconnect, examine the
cable, and then reconnect
with precaution.
Add an adequate quantity
of water in the reserve.
The water should never
exceed the limit of 500 ml
(max).
Consult the instructions
for CLEANING AND MAIN-
TENANCE.
Remove the covers, and
then replace them correctly
to allow the propagation of
the steam.
Remove any dust from the
air intake : A restricted air
flow will affect the mist
quality.
Remove the covers, and
then replace them correctly
to allow the propagation of
the steam.
See the "Dropping the
appliance or accidental
leakage during use" in the
"OPERATION" section.
In these conditions, the
mist is liable to condense
rapidly to form droplets
of water.
VM-H2

HUMIDIFICADOR DE AIRE

ES
21