BOMANN EKI 5014 CB Mode D'emploi page 44

NOTE:
• The display shows the selected setting. The relevant
indicator light next to the display will also light up.
• Please observe that the cooking behavior in the pots
differs. It depends on the nature and the quality of the
cooking vessels.
Enter Off Time
You can limit the cooking time with the
1. Turn the appliance on and select any range or temperature.
2. Press the TIMER button. The display shows "0". The
indicator light next to the display will light up.
3. Set a turn-off time between 1 and 180 minutes by using the
or the button.
NOTE:
• Briefly press the or the
in increments of one minute. The display will show the
desired setting.
• Once you have set a time, the display will remain for a
few seconds. Then the function that you had selected
previously will be shown again.
• If you would like to verify the turn-off time, press the
TIMER one more time. The display will show the
remaining running time for a few seconds.
• You may change the previous turn-off time at any
time. The other settings (HEAT and TEMP.) will
remain.
• After the set time has elapsed, the cooking time will
automatically be turned off and a beep will sound. The
appliance is in stand-by mode again.
• To cancel the turn-off time early, set the TIMER to less
than "1". The cooking plate will turn off and will switch
back to standby mode. You may also turn the appli-
ance off directly with the
Automatic shut-off
The hot plate turns off automatically after 120 minutes, if no
input was given over the operator control panel during this time.
This switching serves as security for you.
Switching off
1. Press the ON/STANDBY button (5).
NOTE:
• The hot plate is reset from its operational state to
standby mode. The fan may continue to run for a
period of time.
• The indicator lights next to the display will go out.
• The display shows the message "– H –" for "Hot" as
long as the temperature of the cooking surface is
higher than 50°C.
44
TIMER button.
button to set the time
ON/STANDBY button.
NOTE:
• The display shows the message "– L –", when the
temperature of the cooking surface is lower than
50°C.
2. Pull the plug.
3. Let the device cool down, before you put it away.
Pan recognition
The device has a pot recognition function. It gives several
warnings to indicate that the cookware has been removed. The
message "– – –" appears on the display. For safety reasons,
the appliance will switch to standby mode after about 15
seconds. The fan may continue running.
In this context, please pay attention to the following:
WARNING:
After use, the hot plate is to be switched off by means of its
regulation and control devices [
and not just by pan recognition.
WARNING: Hazard of burns!
Because of the heat radiated during cooking, dangerously
high temperatures may occur at the cooking zone after the
cooking cycle.
Cleaning
WARNING:
• Always remove the mains lead before cleaning!
• Wait until the machine has cooled down completely!
• Under no circumstances should you immerse the device
in water for cleaning purposes. Otherwise this might result
in an electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
CERAN ® -Glass ceramic Hob
• Clean the surface from food remains when it's still warm
using a moist cloth or tissue.
• Wash the hob using a soft sponge and some water, then
wipe dry with a soft cloth.
• Cleaning agent for glass-ceramics surfaces: In case of
stubborn, baked-in remains, use suitable cleaning products
available at special departments of department stores.
Housing
• Clean the housing after use using a slightly moist cloth.
• Make sure that no fluid matter gets into any of the openings
of the housing. This might damage the device or result in an
electric shock.
ON/STANDBY button (5)]