Operator Code; Enabling Tracer Fluid Injection; Data And Time - Launch VALUE-200 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32

OPERATOR CODE:

Switch the machine on. The MAIN MENU will appear after a few seconds:
Select NEXT MENU:
Select DATA AND CONFIGURAT.:
Select CONFIGURATION:
Select INSERT OPERATOR NO.
It is now possible to input an alphanumeric code (up to 10 characters) that indicates the
number of the operator. This number will appear into all the printouts.

ENABLING TRACER FLUID INJECTION

The optional tracing mechanism may be installed on request on the machine . Follow the
procedure outlined below to enable the option.
Select OPTION from the CONFIGURATION MENU and press ENTER. Type in the code for
enabling tracing. Press key 1 to enable or key 0 to disenable. Press START. After enabling the
tracer, repeat calibration of the oil scale.

DATA AND TIME

The machine holds date and time data in memory for about one year, even if switched off.
Select NEXT MENU, DATA AND CONFIGURAT., CONFIGURATION, and then SET DATE &
TIME. The following screen will be displayed:
Press START to reset the date and time.
INSTRUCTIONS MANUAL
AUTOMATIC PROCEDURE
ASSISTED PROCEDURE
NEXT MENU
GAS AVAIL
XXXX G
CALIBRATION
DATA AND CONFIGURAT.
SERVICE ALARM
BOTTLE FILLING
DATA
CONFIGURATION
SERVICES
PREVIOUS MENU
LANGUAGE
MEASURE UNITS
OPTION
SET DATA & TIME
INSERT OPERATOR N.
hh:mm:ss gg/mm/aa
ENTER CONFIRM
START MODIFY
-28-

Publicité

Table des Matières
loading

Table des Matières