Operation
Indicators
Below you can see an overview of the light indicators on HearIt Mobile
Flashing blue (R1):
Blue (R1):
Flashing blue (R3):
Green (R3-R7):
Flashing red (R5):
Charging
If the HearIt Mobile light indicator R5 fl ashes red during operation, or if the unit cannot be turned on, HearIt Mobile
requires recharging.
1.
Connect the power supply wire to HearIt Mobile's jack
2.
Connect the power supply to a power source and turn on.
3.
The light indicator
R5 lights continuously red during recharging.
4.
When HearIt Mobile is fully recharged, light indicator
* Plugs vary from country to country.
*
R11
1
2
Adjusting volume
1.
Press receiver button
R2+ (volume up) or R2- (volume down) to set comfortable listening level.
2.
The receiver indicators
R3 to R7 illuminate depending on volume level.
R2+
R2-
2
1
Please note:
•
The maximum volume level has been reached if all fi ve indicators
weak adjust the volume on your mobile telephone or contact your hearing care professionel for adjustment of the
telecoil in the hearing aid.
Incoming call
Wireless Bluetooth call activated
No Bluetooth connection
Volume level
Battery low
R11.
R5 lights continuously green.
Please note:
•
We recommend full charging
batteries before use, however,
partly charging the units does
not infl ict damage to them.
3
+
4 Charged
R3 to R7 are illuminated. If the signal is still too
16
16
Operation
Accepting an incoming call
1.
When a call comes in a ringing tone will be heard in the hearing aid or headphones and the receiver
indicator R1 starts blinking blue.
2.
Press the button
R1 to accept the call.
3.
Press the button
R1 to end the call.
1
2
R1
R1
Please note:
•
Only make a single short push to accept or end a call. It may take a couple of seconds before a call is
completely connected or disconnected.
•
The ringing tone of the mobile telephone call may be the same sound as heard from the mobile telephone
itself depending on the mobile telephone used.
•
If HearIt Mobile is turned off when a mobile telephone call comes in, that specifi c call cannot be answered or
ended using HearIt Mobile.
Making a mobile telephone call
1.
Turn on HearIt Mobile by pressing the button
2.
Enter the dial number on the mobile telephone and pick up the handset.
3.
The call is automatically transferred to HearIt Mobile.
4.
To end the call press the button
R1 or end the call on the mobile telephone.
Rejecting an incoming call
1.
When a call comes in a ringing tone will be heard in the hearing aid or headphones and the receiver
indicator R1 starts blinking blue.
2.
Press receiver button
R2- (volume down) for 2 seconds to reject the call.
R2-
1
R1
2
UK/US
3
R1
R1 for up to fi ve seconds.
17
17