Accessories - Dogtra StB-Hawk Mode D'emploi

Battery Charging Procedure
NOTE : The unit has a partial charge when it leaves the Dogtra
facility, upon receipt of the collar, be sure to give it a full 2-hour
1. Attach the charging cable to the beeper collar as shown on
page 29.
2. Plug the charger into a 220-volt wall outlet or, if using the
lithium-polymer batteries (Use a 110-volt charger for U.S.A.).
When properly plugged in, all indicator lights should glow red.
battery cable is unplugged from the unit after a full charge, you
will need to turn the unit on before use.
3. The battery is fully charged within 2 hours. The lights will stay
red during the charging process. The red light will change into a
steady green light when the battery is fully charged (When you
to restart the unit.).
4. After charging, cover the battery charging receptacles with the
rubber plugs on the beeper collar.
30
NOTE : Only use Dogtra-approved batteries, chargers, and
accessories for your Dogtra collars. When a charger is not in use,
disconnect it from the power source.
Charger Info
Manufacturer : HON-KWANG
Manufacturing country : CHINA
Model name : HK-AW-100A150-EU
INPUT : 100~240V~50/60Hz 0.4A /
OUTPUT : 10V 1.5A
WARNING
!
During battery charging, the unit must be close to the wall
outlet and the wall outlet must be easily accessible for
security reasons.

ACCESSORIES

The following item may be purchased separately.
Field Auto Charger
Designed for use with the 10-volt cigarette lighter in
your car.
31