Lubrication - FScurtis FCT02C48V3X-A1X1XX Instructions D'utilisation Et Manuel De Pièces

INSTALLATION INSTRUCTIONS (CONTINUED)

Lubrication

Before operating compressor,
ensure oil is filled to the center of
the sight gauge (see figure 4).
Using any other type of oil may
shorten pump life and damage
valves.
Recommended Oil (2 Options)
FSC-1000A ISO-100 Premium Reciprocating
Compressor Lubricant
12 quart case part number FSC-1000A-12.
Oil Capacity
Approximately 8.5 oz.
Remove cap from oil fill opening. Install breather (found in
parts bag with this manual). Check oil level. See specification
label on compressor pump for the proper oil capacity and
oil type. All lubricated compressor pumps discharge some
condensed water and oil with the compressed air. Install
appropriate water/oil removal equipment and controls as
necessary for the intended application.
Do not use regular automotive oil. Additives in regular motor oil
can cause valve deposits and reduce pump life. For maximum
pump life, drain and replace oil after the first fifty (50) hours of
operation. Then perform oil changes every three (3) months.
Oil Drain
Plug
Sight Gauge
Figure 4 - Lubrication
9
Oil FIll
Area
Full
Low