ESAB PCC-14 Manuel D'instructions page 28

SEcTIoN 2
connections to the Master Power Supply
1 . A power output cable attaches to a large adapter which is installed in the Water OUT ( - ) fitting .
2 . The Pilot Arc cable connects to a small adapter installed in the Water IN ( + ) fitting .
3 . Coolant out hose connects to the large adapter installed in the Water OUT ( - ) fitting .
4 . Coolant in hose connects to the small adapter installed in the Water IN ( + ) fitting .
5 . Torch Switch Extension cable plugs into the Torch Switch Receptacle
6 . The Plumbing Box Control cable connects to the Amphenol receptacle on the rear of the power supply labeled "RE-
MOTE PLUMBING BOX" .
The other ends of all six of the above hoses/cables will connect to the Plumbing Box .
7 . A work cable connects to the "Work" terminal on the front-lower-left of the console . The other end is attached to the
cutting table or work piece .
connections to the Slave Power Supply
1 . A slave control cable has been wired into the master supply . This cable plugs into the slave's Torch Switch Receptacle
(5 pin plug) .
2 . A power output cable attaches to a large adapter which is installed in the Water OUT ( - ) fitting .
3 . A work cable connects to the "Work" terminal on the front-lower-left of the console . The other end is attached to the
cutting table or work piece .
No gas hoses connect to either power supply when a plumbing box is being used.
connections to the rear of the Plumbing Box
1 . The Start, Cut & Shield gas hoses from the regulator panel attach to the rear of the plumbing box .
2 . The Plumbing Box Control cable connects to the Amphenol receptacle labeled "CONTROL CABLE FROM POWER
SOURCE" .
The Torch Switch Extension cable, both power cables, the pilot arc cable and both coolant hoses enter the plumbing box
from the rear and are connected internally .
DEScRIPTIoN / INSTallaTIoN
28