Getting Started; Functions - oneConcept 10026902 Mode D'emploi

• The first step in using your device i scharging it. Connect the device to a USB port on your
PC or plug it into AC power with the included adapter. We suggest changing the device for
4 hours. When charging, the blue led indicator (5) will be blinking and turn to solid red
light when fully charged.
• If you plan on viewing your files on your computer, we suggest using VLC player. The
lastest version can be downloaded for free at www.videolan.org.
• When inserting micro SD card and turning on the device, if the micro SD card is not com-
patible with the system the blue light will be blinking for 20 seconds. The device warns
you to format the card bevore using. Please press ON/OFF, then the blue light will be flashing
very fast to indicate the process of formatting the card. After formatting, you can start other
operations. If no action for 20 seconds, the device will shut down automatically.
Attention: Please note that any files that are saved on the micro SD card will be deleted
when formatting.
• You can shut the device down by holding ON/OFF for a few seconds
Recording video
• Insert MicroSO card (use C 10 hi speed card or better) - press button (4) for a few se-
conds until the red light is on. The red tight should start blinking, indicating it is recording.
• To power the device off. hold down the ON/OFF button for a few seconds and the red LEO
light will turn off.
• To record video, while in video stand by, the LED indicator will be solid red. Press the record
button (4) 2-5 seconds to start the video
• recording. Press the record button again to save your current file and stop recording. Every
10 minutes one file will be saved automatically. If no operation while in stand by for 3 minu-
tes, the device will shut down automatically.
Torch
Press button (1). The 2-LED light torch will be on and will be useful as flashlight and could
also help for video recording or photo when the daylight is not sufficient.
Taking photos
When the device is in stand by mode, press the photo button (2) once, the red LED will
blink once to indicate it is capturing and storing your photo and will return to solid red light
when completed
8

Getting Started

Functions