Inserting/Replacing The Batteries; Maintenance And Cleaning; Declaration Of Conformity (Doc); Technical Data - Renkforce WSF01 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Scanning using the app "Directscan" (Android and iOS)
The app allows you to scan to your smartphone or tablet. The power can be supplied either
by batteries or USB. The documents are transferred directly to your mobile device.
• First, you have to install the app. Search Google Play Store or in Apple App Store for the
app "Directscan" and install it.
• Switch on the scanner (hold down the middle key on the scanner for 3 seconds).
• When the memory card is shown on the display, press either the arrow key up once (DPI)
or the arrow key down (JPG/PDF).
Once the WLAN icon is displayed, press again the middle key on the control panel. The
WLAN icon will now flash red. After a few seconds it will stop flashing and then glows
steadily in blue.
• Now connect your mobile device via WLAN with the scanner. To do this, open the WLAN
settings. In iOS you can locate these settings under the menu item WLAN. In Android you
also switch to settings (gear icon). Tap the connection tab and WLAN.
• Typically a new WLAN network will be displayed that, for example, is called
"DIRECTSCAN-XXXXXX". Connect your device to this WLAN. Now enter the preset pass-
DIRECTSCAN-XXXXXX". Connect your device to this WLAN. Now enter the preset pass-
". Connect your device to this WLAN. Now enter the preset pass-
word "12345678" (without quotes).
• Now start the previously installed app.
• If you want to change any settings before scanning (colour or greyscale, DPI, etc.) you
can do this now in settings (gear icon) under the menu item Scan.
• To scan the document, tap the right scanner icon on the bar below. Push the document
you want to scan from the front into the slot until it is aligned. To perform the scan, tap the
scan button on the app.
After the scan has finished, the document appears briefly on the display. You can edit or
save it now.
• The app also allows you to download the files to your smartphone or tablet, which you
have previously scanned and saved on the memory card.
To do this, tap the left icon with the house in the bar at the bottom. You select the desired
files by tapping them (selected files have a blue check mark on their right). Then down-
load them.
As soon as a device (tablet, smartphone, PC) is connected over WLAN to the
scanner, you can use the device to adjust the scanner's WLAN. To do this, open
the Internet browser and enter the IP address 10.10.1.1 into the address bar. Click
the button "Security Setting". Here you can now change the WLAN-SSID and the
password.
Scanning using the PC software
Here you can scan your documents with the help of the PC software. The power is supplied
via a USB port. The documents are transferred directly to your mobile device. Please note
that unfortunately the software is only available in English.
• First you need to install the software on your PC.
Insert the CD in the appropriate drive of your computer.
If the setup does not start automatically, run the file "setup.exe" manually. It is located in
the main directory on the CD. If a message from Windows
confirm with Yes.
• The connect the scanner via USB yo your computer. The driver will install automatically.
• Switch on the scanner (hold down the middle key on the scanner for 3 seconds).
• If the display shows the PC monitor with a USB plug, press the middle key again. Now the
monitor with the connected scanner should appear on your display.
• Start the software "MagicScan". Typically you can find an appropriate shortcut on your
desktop.
• A small window or a toolbar appears, that lets you launch all the tools.
• The first button on the very left starts "Picture Direct".
To change the settings (colour/greyscale, etc.), click on the gear icon.
In order to scan the page, simply slide it from the front into the slot. The page is automati-
cally pulled through and scanned.
The scan is transferred to the clipboard on your computer. You can then paste (CTRL + V)
the image, for example, into a Word document.
• The second button from the left starts "OCR Direct"
The procedure is the same as "Picture Direct", but here the scan comes as text and can
be opened, for example, directly in Word.
• The third button starts "BCR Direct". Here you can scan your business cards and save the
text to a list.
Create a new card and click on the button Scan Picture. Then insert a business card into
the slot of the scanner.
• The button to the very right starts "Scan and OCR". Here you can scan a page and then
convert it to text.
First, click on the button at the top left. Then slide in the document that you want to scan.
After scanning you can convert the document to text if you like.
user account control appears,
®
Inserting/replacing the batteries
• To install or change the batteries, open first the battery cover on the bottom of the scanner.
To do this, press the lever of the battery cover towards the cover and then lift it out.
• You need to remove the old batteries before you can insert new ones.
• Insert the 6 new AA type batteries into the battery compartment.
Please pay attention to the correct polarity. The markings in the battery compartment
illustrate how to insert the batteries.
• Finally, close the cover of the battery compartment.
• Inserting/replacing the batteries is now complete.
Maintenance and cleaning
The product is maintenance-free. Maintenance or repair work may be performed only by
qualified personnel or a specialised repair shop. The product contains no parts that require
servicing. Therefore, do not open it.
To clean the outside of the product, a dry, soft and clean cloth is sufficient.
Do not use abrasive cleaning agents, rubbing alcohol or other chemical solutions,
which may damage the casing or even impair operation.
Disposal
a) Product
Electronic devices are recyclable waste materials and must not be disposed of in
the household waste!
Please dispose of the product, when it is no longer of use, according to the cur-
rent statutory requirements.
Remove any inserted normal or rechargeable batteries and dispose of them sepa-
rately from the product.
b) Batteries
You as the ultimate consumer are legally obliged (Regulation on spent batteries) to return all
dead batteries; disposal in the household waste is prohibited!
Batteries containing hazardous substances are labelled with the symbol shown
to indicate that disposal in household waste is forbidden. The symbols of the
critical heavy metals are: Cd=cadmium, Hg=mercury, Pb=lead (marking can be
seen on the battery / rechargeable battery, e.g., underneath the refuse bin symbol
shown on the left).
You can hand in your used batteries at the collection points of your community at no cost or
everywhere where batteries/accumulators are sold!
You thereby fulfil your statutory obligations and contribute to the protection of the environ-
ment.
Declaration of conformity (DOC)
We, Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declares that
this product conforms to the fundamental requirements and other relevant regulations of
the 1999/5/EC directive.
The Declaration of Conformity for this product is available at
www.conrad.com.
Technical Data
Power supply ........................................... via USB or 6 AA batteries (not included)
Operating voltage....................................5 V/DC
Power consumption................................max. 1 A
Max. battery life ...................................... without WLAN, max. 5 hours or 950 scans; with
Display ......................................................TFT LCD Display 1.45"
WLAN ........................................................802.11b/g/n, WPA2
Max. scan size (W x L) ...........................21.6 x 120 cm
Supported scan resolution ....................300 DPI (standard), 600 DPI, 1200 DPI
Supported operating systems ............... Windows
Supported memory cards ......................micro SD, micro SDHC; max. 32 GB
Supported file format..............................JPEG, PDF
Connections .............................................1x USB2.0 (mini-plug), 1x micro SD card slot
Dimensions (L x W x H) ..........................285 x 50 x 43 mm
Cable length mini USB cable.................approx. 1800 mm
Weight .......................................................232 g (without batteries and cable)
Operating conditions ..............................5 °C to +35 °C; 10% to 90% relative humidity
Storage conditions..................................-20 °C to +60 °C; 10% to 90% relative humidity
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent
the technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE.
WLAN, max. 1 hour or 260 Scans
XP from SP1 (32 bit only), Windows Vis-
®
ta™, Windows
7, Windows
8.1 (32 and 64 bit); An-
®
®
droid ab 4.0.3, Apple iOS from 5.0; Windows Phone 8.1

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1277811

Table des Matières