weasy SIL85 Manuel D'instructions page 4

• Make sure that the voltage rating on the typeplate
corresponds to your main voltage of your installation. If
this is not the case, contact the dealer and do not
connect the unit
• Please keep this document at hand and give it to the
future owner in case of transfer of your device
• Never leave the unit unattended while in operation.
• The device must not be used if it has been dropped, it
obvious signs of damage are visible or if it has leaks.
Remark: Please unlock the lid after each use, and re-insert the paper stand after vacuuming, it
prevents pressure from being applied to the sealing foam.
Technical Specifications
Rated voltage: AC 220-240V 50Hz (EU) / AC120V 60Hz (US)
Rated power:85w.
Vacuum Degree: -60kpa. Noise value: less than 75Db
Sealing time:10 seconds
1. Lid Lock Release button
2. Vacuum releasing valve
3. Air suction
4. Press 5 or 6 for cancel
5. Vacuum Button
6. Seal Button
7. Indicator
8. Sealing Foam
9. Heat sealing strip
10. Thermal fuse
11. Vacuum channel
12. Lid lock Release button
13.
Paper stand
14. Advice sticker for close lid
15. Accessories vacuum hose