Setting In Accordance With Image Contents - Plus U3-1080 Mode D'emploi

Setting the RGB/YCbCr connector
The RGB/YCbCr connector can be switched and used as
the component video signal (YCbCr) input connector.
1
With the FLIP COVER of the remote con-
trol open, press the MENU button to dis-
play the Advanced menu, then use the
cursor / keys to select "COLOR".
2
Use the cursor
"SOURCE CHANGE".
3
Use the cursor
"SOURCE CHANGE".
The following can be selected.
RGB YCbCr
When component video (YCbCr) input is used,
use the optional component video cable.
/ keys to select
/ keys to set the
E – 27
S e t t i n g i n A c c o r d a n c e
W i t h I m a g e C o n t e n t s
Setting the Display Frame
The display frame can be set individually for each input.
1
Select the input for image selection (page
16).
2
With the FLIP COVER of the remote con-
trol open, press the MENU button to dis-
play the Advanced menu, then use the
cursor / keys to select "VIEW".
3
Display the frame, then use the cursor
keys to select "ASPECT".
4
Use the cursor
"ASPECT" ratio.
Any of the following four different settings can be
selected for images.
REAL (input signal projection without pixel re-
placement)
AUTO (projection after automatic input signal
zoom in/zoom out)
DIRECT (the original aspect ratio of the image
is maintained at all times)
4:3 → 16:9 (4:3 aspect ratio images are pro-
jected after conversion to 16:9 aspect ratio)
Setting Filter
This is used to set the sharpness during pixel conversion
(image compression/enlargement).
1
With the FLIP COVER of the remote con-
trol open, press the MENU button to dis-
play the Advanced menu, then use the
cursor / keys to select "VIEW".
2
Display the frame, then use the cursor
keys to select "FILTER".
3
Use the cursor
sharpness.
/
/ keys to set the
/
/ keys to set the
To close the menu
Press the CANCEL button.