Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ATHENA Series
Height Adjustable Keypad Quick Guide
UP & DOWN
Basic Touchscreen Keypad Operation
•
The touchscreen keypad buttons lockout after inactivity. If the buttons are not touched for 30 seconds, the M1, M2, M3 and
M4 buttons will lock. To unlock, touch either the up or down button once and all buttons will re-activate.
•
Four preferred heights can be set using the Memory buttons (M1, M2, M3 & M4).
This height adjustable base is equipped with an anti-collision feature. If the desk encounters an immovable object while
•
going up or down, the desk will automatically reverse.
•
Factory minimum and maximum preset height values are adjustable. Please contact customer service for assistance.
M1
M1
M2
M3
Note/Caution:
•
If you encounter an issue with your desk, unplug for 2 minutes and plug back into a confirmed power source.
Saved height presets will not be lost in the event of a power outage.
•
•
Do not exceed recommended weight limit of:
•
Recommended weight limit must also include the weight of the desktop/worksurface.
•
Install with 2.5cm (1") clearance around work surface to prevent finger pinch.
•
Ensure vertical motion is clear of obstruction
•
Duty cycle: 10% of the industry standard run cycle. For example, two minutes of constant operation should be
followed by 18 minutes of inactivity.
•
The design of Athena does not support the lifting of extreme weight loads, for example, a person.
•
Do not open electrical components (controller, motor housing or keypad).
•
Athena is designed for indoor use only.
•
In the unlikely event that the desk becomes loose/shaky, check that all screws and bolts are securely installed
and tight.
QUESTIONS OR CONCERNS?
Please contact Customer Service
T 1-800-567-3060
M-F 6am - 4:30 pm PST
cs@heartwood.ca
NOVEMBER 22, 2019 REV B
M1
M2
Up & Down Buttons
When the Up or Down buttons
are touched, the desk will move
M1
M2
M2
M3
M4
until pressure is removed from
the button.
Memory Buttons (M1, M2
M3 & M4)
Using the Up & Down buttons,
M4
position the desk at a desired
height. Press and hold either
M1, M2, M3 or M4 for 5
seconds. Once a "beep" is
heard, the height is saved.
Quick guide should remain with the product after
MEMORY
M3
M4
M3
M4
2 LEG MODEL (ATH-E1-2LEG) - 100kg (220lbs)
3 LEG MODEL (ATH-E1-3LEG) - 150kg (330lbs)
assembly for user reference.
DISPLAY
Display Screen
Displays the current height of
the desk.
Page 1 of 2
Publicité
Table des Matières
