Nicols PAR LED 123 FC IP Manuel D'utilisation page 5

installation, operation and maintenance.
Please keep this User Manual for future consultation. If you sell the unit to another user, be
sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before using the unit.
Before operating, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
It's important to ground the yellow/green conductor to earth in order to avoid electric shock.
The unit is for indoor and outdoor use.
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
Disconnect mains power before fuse replacement or servicing.
Make sure there are not flammable materials close to the unit while operating as it is fire
hazard.
Use safety cable when fixes this unit.
Maximum ambient temperature is 40°C and don't operate it where the temperature is higher
than this.
There are no user serviceable parts inside the fixture. Do not open the housing or attempt
any repairs by yourself. In the unlikely event your fixture may require service, please contact
the nearest authorized technical assistance center and always use the same type spare
parts.
The housing must be replaced if they are visibly damaged.
Do not touch any wire during operation as high voltage may cause electric shock.
Do not look directly at the LED light beam while the fixture is on.
Do not look at the beam light directly to avoid any visual problems.
Possibly hazardous optical radiation emitted from this product.
2. Technical specifications
Weight: 3.5kg
Size: 184*184*170mm
Power input: AC230V/50 HZ
Wattage: 60W
LEDS: 12*tri-3W LEDs
Beam angle: 30 degree
IP rate: IP65
8-
LED display for easier operation.
Selectable built-in programs, Auto running, DMX mode, M/S mode.
DMX modes: 3channels, 4channels, 8channels
3. Working modes
After power on, Press "MODE"button to activate the main menu: Built-in programs mode,
Auto running mode, DMX mode, Slave mode.
"SETUP" is to set the relative specification for current mode.
"UP" is to add the value of current specification.
"DOWN" is to decrease the value of current specification.
Built-in programs-- running one of 10 built-in programs
Auto run: running built-in programs one after another in continuous loop.
DMX mode: controlled by DMX controller
Slave mode: the projectors in this mode will be synchronously run with the projectors in
master mode.
3.1 Built-in program mode
Press "mode" until it shows "Pr.xx" to enter into built-in programs mode. Press "up" and
"down" to select program from Pr.01～Pr.10. Press "setup" button to enter into the running
speed menu "SP××". Press "up" and "down" button to set the speed value from SP01～
SP100（FL）. Press "setup" button to enter into the strobe menu "FS××". Press "up" and
"down" to set up strobe value from FS00～99.
3.2 Auto running mode
Press "mode" until it shows "AUTO" to enter into auto running mode
Press "setup" button to enter into the running speed menu "SP××". Press "up"and "down"
button to set the speed value from SP01～SP100 (FL).
Press "setup" button to enter into the strobe menu "FS××". Press "up" and "down" to set up
strobe value from FS00～99. Press "setup" button to enter into the fading menu "Fd××".
Press "up" and "down" to set up fading value from Fd00~99
3.3 DMX mode
Press "mode" until it shows "d.×××"to enter into DMX mode. Press "UP" and "DOWN" button
to set up the DMX address from d.001～d.512. Press "setup" button to enter into the DMX
9-