ATTENTION: If your hood works as an air re-circulator (see point 4); it is not necessary to drill
130mm diameter holes.
ii. Use the 4 screws; washers and M4 nuts to fix the cooker hood to a kitchen cupboard.
Check that your fixings are correctly located, by temporarily fitting the cooker hood. If correct,
fit the unit into position. Tighten the screws if necessary.
ATTENTION: In case the lamps do not work, make sure they are well tightened
7.CONTROL PANEL
Slide switch ① to "1", the lamp be on; push to "0", the lamp be off.
c)
Slide switch ② to "3
d)
speeds respectively.
8.CHANGE LAMPS
To replace the lamps, remove the metal filter as below and change the bulbs. Replace them
appliance in operation for 15 minutes after cooking is terminated. Before any cleaning or
maintenance work is carried out; disconnect the cooker hood from the mains power supply.
Ensure that it is switched off at the wall socket and plug is withdrawn.
- All external surfaces and controls can be cleaned using a little washing-up liquid applied with
a soft sponge or cloth. Wipe dry using a soft cloth.
0 ", the motor will be on "off, low, mid, high"
with bulbs in same type and within
220-240V/40W.
CAUTION: Do not touch bulbs with your
bare hands.
9.CLEANING AND MAINTENANCE
- It is recommended to operate the
appliance prior to cooking.
- It is recommended to leave the