Installation Instructions - FAR HC250B Notice D'utilisation

ATTENTION: To work as an air recirculator; you need to install the carbon filter on hood.
Carbon filter is not supplied together with the product and you can contact your local
distributor for further information. As shown in picture below; put the carbon filter in position
and put the U-shaped hangers back into its position.

6.INSTALLATION INSTRUCTIONS

The cooker hoods must be placed at a minimum distance of 65cm above the cooking surface of
a hob.
Wall mounting installation
i. To mount on the wall, drill two 8mm holes 430mm apart with the vent hole on the top of the
cooker hood in the middle. Make sure the hood is aligned directly over the hob.
ii. Insert the plastic wall plugs (supplied) into the holes.
iii. Insert the screws into the plastic wall plugs and tighten them leaving 1mm protruding from the
wall.
iv. Mount the cooker hood onto the two screws and mark the bottom two screw positions.
v. Remove the hood and drill the bottom two screw holes and insert the plastic wall plugs.
vi. Mount the hood on the top screws, insert the bottom screws and fully tighten all the screws.
b) Cupboard mounting installation
i. Drill a 130mm diameter and four 5mm diameter holes as per below picture