AEG LBS 5676 Mode D'emploi page 20

English
20
NOTE: To prevent the skin on your hand from cracking,
apply a moisturizing lotion after treatment.
1. Open the battery compartment. Insert two 1.5 V type
"AA/R6" batteries. Then close the battery compartment
again.
2. Install the desired attachment on the device.
3. Switch on the device. The device features two speed
settings with clockwise and anticlockwise rotation each
(R = right, L = left). Start by selecting the low speed
setting.
4. Switch off the device after use.
Lady shaver
1. Open the battery compartment. Insert two 1.5 V type
"AA/R6" batteries. Then close the battery compartment
again.
2. Switch on the device.
3. Shaving armpits and bikini zone: Push the switch (13) to
the right (). The long hair trimmers flex during use.
Trimming bikini zone: Push the switch (13) to the left ().
The long hair trimmers are fixed. For trimming longer
hair, install the long hair attachment on the device.
WARNING!
• Shaving armpits and bikini zone: The skin in
those areas is very sensitive. Therefore always
tighten the skin with one hand in order to avoid
injuries.
• Pay attention to skin imperfections such as warts.
Those must not be touched by the long hair trim-
mer.
4. Slowly guide the device against the direction of the hair.
The long hair trimmer and the shaving foil should always
touch the skin at the same time.
5. Switch off the device after use.
NOTE: Avoid using irritating substances such as alcohol-
based deodorants directly after hair-removal.
Eyebrow trimmer
1. Remove the cover.
2. Slide the battery compartment cover off. Insert one 1.5 V
type "AAA/R03" battery. Then slide the battery compart-
ment cover back on again.
3. If necessary, install the attachment on the device. The at-
tachment features two different cutting lengths, depend-
ing on the orientation of the attachment.
4. Switch on the device.
5. Guide the shaving head over the spots of the eyebrows
you wish to shave.
6. Switch off the device after use.
Cleaning
CAUTION:
• Do not immerse the device in water. That could de-
stroy the electronics.
• Do not use sharp or abrasive cleaning agents.
• Clean the devices after each use.
• Switch off the devices before cleaning. Remove the bat-
teries.
• Wipe the housing of the devices with a slightly damp
cloth.
Lady shaver
CAUTION: The shaving foil (14) must not be cleaned with
the brush.
• Use the cleaning brush for cleaning
the blade block and the inside of
the shaving head.
Removing the blade block: Pull
off the shaving foil holder in an up-
wards direction. Remove the blade
block. To do so, grap the long hair
trimmer and pull out the blade
block in an upwards direction.
Installing the blade block: Slide
the switch (13) to the left (). Insert
the blade block into the shaving
head by slightly applying pressure.
The blade block will click into place. Then reattach the
shaving foil holder to the device.
• Regularly apply 1-2 drops of acid-free oil to the blade
block and long hair trimmer.
Eyebrow trimmer
Remove the blade block as shown for easy cleaning.
1. Open the lock ①. Re-
move the blade block ②.
2. First insert the blade
block at the top of the
shaving head ①. Push
down the blade block ②.
Then secure the blade
block using the lock.