Baldwin 8252402AC1LH Manuel D'installation Et De Programmation page 5

1. Verify that position #2 of the "Settings Switch" is in the OFF position.
(Refer to section 10.)
2. Work with the door open (away from jamb) to avoid accidental lock out.
3. Make sure the bolt is in the extended (locked) position.
7. Install batteries into battery pack.
Note: Do not install battery pack into unit until you start step 8.
a. Install 4 new AA Alkaline batteries.
Install the new batteries as indicated in illustration. Make
sure batteries lie flat in holder. For best performance,
rechargeable batteries are not recommended.
Alkaline Battery WARNING:
Do not dispose of in fire, recharge, put in backwards, disassemble, mix with
used or other battery types. May explode or leak and cause personal injury.
IMPORTANT: DO NOT SKIP THE FOLLOWING STEP.
LOCK WILL NOT BE ABLE TO OPERATE PROPERLY!
8. Automatic - Bolt Direction Determination (Door Handing).
● In the steps below, the Keyless Entry Deadbolt mechanism
automatically determines the "door handing" and sets the proper
direction for motor to rotate. The system will drive the bolt several
times during this process.
LOCK
Button
r i
t e
e x
Important before proceeding:
Battery Pack
Tab
o r
Turnpiece
2
LED
i n
t e
r i
o r
2
1
Continued
5