Publicité
Les langues disponibles
Les langues disponibles
g Operating Instruction
Package contents:
1x USB 2.0 hub
1x 5V 1,2 A power supply unit
1x operating instructions
System requirements:
•
Operating system Windows 2000 from SP 3,
XP from SP 1, Vista or Mac OS 10.x
•
Free USB connection, preferably USB 2.0
Safety instructions:
You have acquired a high-quality, electronic accessory
for your computer which is universally useable. Please
observe the following points:
•
Protect the device against pressure and impact.
•
Do not expose the device to moisture. The precision
contacts can be damaged.
•
To not connect the device if the device, the
connection lead or the mains adapter are damaged.
Only authorised qualifi ed personal is allowed to repair
the mains adapter.
•
The device or other components must only be
repaired in a specialist shop or in a service centre.
•
Only use the enclosed original mains adapter or
original spare parts.
•
Only use the enclosed USB connection cable without
extension. Otherwise, the data security can be
affected.
•
Make sure that all connected devices are CE-marked.
•
Avoid heat sources and direct sunlight exposure.
•
Attention! Keep electrical equipment and electronic
devices out of reach of children.
•
Attention! Keep packaging materials out of reach of
children! Danger of suffocation!
Connection of the power supply unit:
1. Connect the mains adapter with the USB hub.
2. Connect the mains adapter to a power outlet
Note: Please make sure that the mains voltage
corresponds to the technical data of the adapter.
Putting into operation:
1. Switch on your PC and wait until it has started up.
Connect the USB hub with your PC/notebook by
means of the enclosed USB cable.
2. Please make sure that no terminal device is
connected when you install the USB hub.
Note: When connecting and disconnecting the USB
hub and the USB devices, different messages can
appear on your screen. Contact a specialist or consult
the manual of your computer or operating system if
you have any questions.
3. Now you can connect your USB peripheral devices
(e.g. printer, scanner etc.) to the USB hub. When
installing the devices you have to install every
devices separately, i.e. please wait until the drivers
of the respective device have been completely
installed before installing another device.
4. It is also recommendable – as far as this is possible –
to supply the terminal devices which are connected
to the hub with power of their own.
Note: When connecting the USB hub, you do not have
to install drivers (are included in the operating system
Windows 2000 from SP3, XP from SP1, Vista or
Mac OS 10.x). A driver may be necessary for the
connected USB devices. This one can be obtained
from the manufacturer of the respective device or
when purchasing such a device.
Support and contact information
If products are defective:
Please contact your dealer or Hama Product Consulting if
you have any claims.
Internet/World Wide Web:
Product support or product information can be found at
www.hama.com
Support hotline – Hama Product Consulting::
Tel. + 49 (0) 9091 – 502-115
Fax +49 (0) 9091 – 502-272
e-mail: produktberatung@hama.de
3
Publicité
