Napoleon DLR35 Instructions D'installation page 2

REAL ROCKS MUST NOT BE USED IN THIS APPLIANCE. HEAT WILL CAUSE THEM TO EXPLODE
NOTE: Log numbers are located on the bottom of the logs.
1. Remove all glass media and discard.
2. Place rocks around the burner making sure not to cover
any burner ports or the pilot.
4. Add the two remaining logs (#7) resting them on the
previous logs, as shown above. NOTE: If the fl ame is
impinging on the media it is recommended that the
position be adjusted away from the fl ame to prevent
excess carbon build up.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada
DLR35 ROCK
INSTALLATION INSTRUCTIONS
FOR USE WITH B35NG IN THE HDX35 SERIES
!
7
WARNING
3. Add the two lower logs on the left (#3) and right (#13)
side of the burner.
5. Spread a small amount of glowing embers over the
centre of the burner as close to the burner ports as
possible.
• (705)721-1212 • fax (705)722-6031
3
13
• www.napoleonfireplaces.com
W415-1524 / 07.20.15