Prepare The Remote Control; Get Started - Anker Nebula Apollo Mode D'emploi

EN

2. Prepare the Remote Control

The remote control comes with two coin batteries.
① For first-time use, remove the battery insulation tabs to activate the
remote control batteries.
② To replace the batteries, slide open the battery compartment, insert
new batteries (matching the polarity (+/-) indicated), and close the
battery compartment.
11

3. Get Started

① For first-time use, fully charge the built-in battery using the provided
adapter.
② Hold
for 2 seconds on the projector to turn it on.
③ Turn the device towards a suitable projection surface or wall.
④ Adjust the focus by rotating the focus adjusting knob.
EN
12