quiko QK-CE220RL4 Guide De Démarrage Rapide

QUICK GUIDE
QK-CE220RL4
CONTROL BOARD FOR 230V SLIDING GATES
CHECKING IF THE MOTOR TURNS IN THE RIGHT DIRECTION
Once all the connec ons have been done and the system is ready to start, before se ng the system
it is important to check that the motors turn in the right direc on. To do that:
1. Remove electricity.
2. Unlock the motor and manually put the leaf in the middle.
3. Give electricity.
4. Give a first start impulse to the system with remote control or push - bu on.
5. Make sure that the motor opens.
6. If the motor closes, swap the phases cables of the motor (13-15) as well as limit switch cables (5-6)
MOTOR
13 15
13 open
14 15
13
14 common
M
15 close
7. Once you have swapped motor phases cables
above and make sure that now the motor opens at first start signal a er giving electricity.
8. The system is now ready for setup.
INSTALLING RADIO MODULE
Important no ce: radio module is by factory installed on the control board plas c box. The radio
signal range is good enough in most cases. Shall you wish to increase the radio range even more,
install the radio module as one the following examples.
ANTENNA HOUSING WITH
INSIDE THE ANTENNA HOUSING
op onal
QK-AN433_V4
Quiko Italy declares under their own responsibility that the product complies with the main safety requirements issued
by the following direc ves: 1) Radio Sets 1999/05/EC – 2) Low voltage 2006/95/EC – 3) Electromagne c compa bility
2004/108/EC and any revisions thereof, and complies with the provisions that implement said direc ves in the na onal
legisla on of the Country where the products are to be used.
®
V21
HS2122
LIMIT SWITCHES
5 6
5 6
5 closing limit switch N.C.
6 opening limit switch N.C.
as well as limit switch cables , repeat the procedure
INSIDE THE FLASHING LAMP
FLASHING LAMP
quikoitaly.com
MADE IN ITALY
®
MADE IN ITALY
op onal QK-BRALUX