Additional Safety Rules For Drills - GMC BN18SB Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
condition that may affect the operation of the power
tool. If damaged, have the power tool repaired before use.
Accidents are caused by poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are less likely to
bind and are easier to control.
g. Use the power tool, accessories and tool bits in
accordance with these instructions and in the manner
intended for the particular type of power tool, taking
into account the working conditions and the work
to be performed. Failure to use the tool for its intended
purposes could result in a hazardous situation and may
invalidate the warranty.
5. SERVICE
a. Have your power tool serviced by a qualified repair
technician, using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
NOTE: The tool must be used only for its prescribed
purpose. Any use other than those mentioned in this manual
will be considered a case of misuse. The user and not
the manufacturer shall be liable for any damage or injury
resulting from such cases of misuse. To use this tool properly
observe the safety regulations, assembly instructions and
operating instructions, which can be found in this manual.
All persons who use and service the machine must be
informed about its potential hazards and be acquainted with
this Manual. Children and frail people must not use this tool.
Children should be supervised at all times if they are in the
area in which the tool is being used. It is also imperative
that you observe the accident prevention regulations in
force in your area. The same applies for general rules of
occupational health and safety. The manufacturer shall
not be liable for any changes made to the tool nor for any
damage resulting from such changes. Even when the tool is
used as prescribed it is not possible to eliminate all residual
risk factors.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice. The
rating plate on your tool may show symbols. These represent
important information about the product or instructions on
its use.

Additional safety rules for drills

Wear ear protectors with impact drills. Exposure to noise
can cause hearing loss.
Use auxiliary handles supplied with the tool. Loss of
control can cause personal injury.
• If possible, always use clamps or a vice to hold your work.
• Always switch off before you put the drill down.
• Ensure that the lighting is adequate.
• Do not put pressure on the drill, such that it slows the
motor down. Allow the drill bit to cut without pressure. You
will get better results and you will be taking better care of
your tool.
• Keep the area free of tripping hazards.
• Do not let anyone under 18 years operate this tool.
• Only use accessory bits in good condition.
• Before drilling, check that there is sufficient clearance for
the drill bit under the workpiece.
• Do not touch the bit after operation. It will be very hot.
• Keep your hands away from under the workpiece.
• Never use your hands to remove sawdust, chips or waste
close by the bit.
• Rags, cloths, cord, string and the like should never be left
around the work area.
• Support the work properly.
• If you are interrupted when operating the drill, complete
the process and switch off before looking up.
• Periodically check that all nuts, bolts and other fixings are
properly tightened.
• When using the drill, use safety equipment including
safety glasses or shield, ear defenders, and protective
clothing including safety gloves. Wear a dust mask if the
drilling operation creates dust.
If in doubt, do not plug in the tool. Using a power source
with a voltage less than the nameplate rating is harmful to
the motor.
5
GB

Publicité

Table des Matières
loading

Produits Connexes pour GMC BN18SB

Table des Matières