First Use - Oral-B iO Mode D'emploi

English
Important Information
• This toothbrush, charger and pouch
(accessory) contain NdFeB magnets and
generate magnetic fields. If you use a medical
device or have an implanted medical device,
consult with the medical device manufacturer
or a physician, if you have questions about
safely using your Oral-B iO toothbrush.
• Your Oral-B toothbrush can be used with your
smartphone (find details under «Connecting
your toothbrush to your Smartphone»). To
avoid electromagnetic interference and/or
compatibility conflicts, disable Bluetooth® on
your toothbrush handle (5) before using it in
surroundings, such as aircrafts or specially
marked areas in hospitals.
• Disable Bluetooth by entering the «Settings»
menu on the interactive display (4) ->
Bluetooth -> disable. Follow the same
procedure to enable Bluetooth again.
• Persons with pacemakers should always keep
the toothbrush more than six inches (15
centimeters) from the pacemaker while
turned on. Anytime you suspect interference
is taking place disable Bluetooth.
• For satisfying RF exposure compliance
requirements, body-worn operations are
restricted to belt-clips, holsters or similar
accessories that have no metallic component
in the assembly and must provide at least
7.9 inches (20 centimeters) separation
between the device, including its antenna, and
the user's body.
Specifications
For voltage specifications refer to the bottom of
the charging unit.

First use

Please wake up your toothbrush by pressing the
on/off button (7) and follow the instructions on
the interactive display (4) to get started for first
time setup.
If not further instructed on the display, you may
toggle with the mode button (8) and select with
the on/off button (7).
You may change the settings via the «Settings»
menu (17) at any time.
Charging and Operating
• To charge the battery place the toothbrush on
the plugged-in charger (6).
• The charge level is indicated on the interactive
display (4). Once it is fully charged the display
turns off. A full charge typically takes 3 hours.
• If the battery is running low the motor reduces
its speed and the Smart Pressure Sensor (3)
shortly blinks in red. Once the battery is empty,
the motor stops; it will need at least a 5-minute
charge for one usage.
Note: In case the battery is empty (display off),
charge at least for 30 minutes.
• You can always store the handle on the
plugged-in charger to maintain it at full power;
a battery overcharge is prevented by device.
Note: Store handle at room temperature for
optimal battery maintenance.
Caution: Do not expose handle to temperatures
higher than 50°C / 122°F.
Using your toothbrush
Start Brushing
Place the brush head on the handle. A small gap
should remain between handle and brush head.
Lift the handle off the plugged-in charger or
simply pick it up to wake up the handle (display
turns on). Wet brush head and apply toothpaste.
To avoid splashing, guide the brush head to your
teeth before switching the handle on by pressing
the on/off button.
Note: Display turns off after some seconds. You may
press the on/off button to activate display again.
Guide the brush head from tooth to tooth. Brush
the outsides, the insides and the chewing
surfaces. Brush all four quadrants of your mouth
equally. You may also consult your dentist or
dental hygienist about the right technique for
you. After brushing, the display gives you
feedback based on your brushing time.
In the first days of using any electric toothbrush,
your gums may bleed slightly. In general, bleeding
should stop after a few days. Should it persist
after 2 weeks, please consult your dentist or
dental hygienist. If you have sensitive teeth and/
or gums, Oral-B recommends using the
«Sensitive» or «Super Sensitive» modes (optional
in combination with an Oral-B «Gentle Care»
brush head (d)).
Timer
The timer signals with a short stuttering sound at
30-seconds intervals to move to the next
quadrant of your mouth. A long stuttering sound
indicates the end of the professionally
recommended 2-minute brushing time.
The timer memorizes the elapsed brushing time,
even when the handle is briefly switched off
during brushing. The timer resets if pausing
longer than 30 seconds or placing the handle on
the plugged-in charger.
Note: During the use of the Oral-B App, the timer
may be deactivated for some features.
Note: You may also customize the timer settings
via Oral-B App.
7