Setting The Meter; Setting The Time Format; Setting The Buzzer - VISIOMED Bewell connect MyGluco BW-GL1 Mode D'emploi

TEST STRIP
1- Absorbent Hole
2- Confirmation Window
3- Test Strip Handle
4- Contact Bars
ATTENTION:
The front side of test strip should face up
when inserting test strip.
Test results might be wrong if the contact bar is
not fully inserted into the test slot.
NOTE: The BW-GL1 MyGluco monitor should only be used with BW-STGL1 MyGluco Test Strips.
Using other test strips with this meter can produce inaccurate results.

3. SETTING THE METER

Before using your meter for the first time or if you change the meter battery, you should
check and update these settings.
ENTERING THE SETTING MODE (A)
Start with the meter off (no test strip inserted). Press S.
1. SETTING THE DATE
The sequence of the date setting is: YEAR -> MONTH -> DAY. With the YEAR / MONTH
/ DAY flashing in sequence, press UP or DOWN until the correct year/month/day ap-
pears. Press REPEAT.

2. SETTING THE TIME FORMAT

Press UP or DOWN to select the desired time format --- 12h or 24h. Press REPEAT.
3. SETTING THE TIME
With the HOUR / MINUTE flashing in sequence, press UP or DOWN until the correct
hour/minute appears. Press REPEAT.
4. SETTING THE UNIT OF MEASUREMENT
Press UP or DOWN to switch between mg/dL and mmol/L. Press REPEAT.

5. SETTING THE BUZZER

With the buzzer displays, press UP or DOWN to switch between "On" and "OFF". Press
REPEAT.
BewellConnect - BW-GL1 - User Manual - 052015
1
2
3
4
31