Ribitech PROMKIT300 Manuel D'instructions Et D'utilisation page 17

4.5- Switching on and off [6]
To start tool: place ON / OFF switch [6] on "1".
To stop tool: place ON / OFF switch [6] on "0".
4.6- Variable speed control [9]
This tool is fitted with speed control selector [9].
You can adjust the speed by rotating the selector from position 1
to 6 to adjust best speed (from 8000 to 32500 rotations/minute).
The rotational speed to be used will depend upon the material
being worked on.
Remarks:
1. Plastic and materials that melt at low temperatures should be cut at low speeds
2. Polishing, buffing and cleaning with a wire brush must be done at speeds below 15,000 RPM to
prevent damage to the brush and material.
Note: Wire bristles are likely to get loosen by the brush even during normal operation.
3. Wood should be cut at high speed
4. Iron or steel should be cut at top speed if using tungsten carbide accessory, but at slower speeds if
using high speed steel cutters.
5. If a high speed steel cutter starts to chatter - this normally means it is running too slow.
6. Aluminium, copper alloys, lead alloys, zinc alloys and tin may be cut at various speeds,
depending on the type of cutting being done. Use paraffin or other suitable lubricant on the cutter
to prevent the cut material from adhering to the cutter teeth.
V. OPERATION
5.1- Intended use
- The product is intended for indoor domestic use.
- The product is intended for light works of drilling,
and polishing of wood, metal, plastic and stone.
Reminder: Do not force a small tool or accessory to do the job of a heavy duty tool.
- Never use tool and/or accessories on persons and/or animals.
5.2- Operation:
1. Wear appropriate protective equipment.
2. Insert accessory in the collet.
Note: Make sure to use the collet that matches the shank diameter of the accessory you intend to use.
Do not force a larger diameter shank into a smaller collet.
3. Prepare material for work
4. Secure material, if necessary.
Do not use your own weight or body to hold material.
5. Connect tool to a power source (according to characteristics on product).
6. Firmly hold tool. Always maintain a balanced and secured position.
7. Press switch [6] to start tool. Adjust speed with the variable speed selector [9] according to
material and work to perform.
8. Place accessory on material. Do not make sudden movements.
Adjust speed with speed selector [9] according to work and material.
Note: the accessory must be rotating when you approach it to the material; never start tool with
accessory touching the material or any other surface.
Tips:
- Become familiar with the proper use of the tool, for example before starting your work, practice
on scrap material in order to find the best speed for the accessory you are using and the job to be
done.
sanding, carving, engraving, routing, cleaning
Fig. 8