Ribitech PROMKIT300 Manuel D'instructions Et D'utilisation page 14

Before further use or reuse of the tool, tool should be carefully checked to determine that it will
operate properly and perform its intended function.
Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting
and any other conditions that may affect its operation.
20. Defective switches or other part that is damaged should be properly repaired or
replaced by an authorized service centre. Do not use the tool if the switch does not turn it on and off.
21. Warning
The use of any accessory or attachment, other than those recommended in this instruction
manual, may present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
22. Have your tool repaired by a qualified person
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in
an authorized service centre is recommended.
This electric tool is in accordance with the relevant safety requirements. Repairs should only be
carried out by qualified persons using original spare parts, otherwise this may result in considerable
danger to the user.
23. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
SPECIAL WARNINGS WHEN USING THE PRODUCT
1. Become familiar with the controls and the proper use of the equipment.
2. The use of this product by children is forbidden.
3. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of
the product by a person responsible for their safety.
4. Use only accessories with a permissible speed at least as high as the no-load speed of the machine.
The outside diameter and the thickness of the accessory must correspond with the tool's rated
capacity.
The arbor size of wheels, flanges, backing pads or any other accessory must properly fit the spindle of
the tool.
Make sure that accessories are assembled according to instructions.
5. Do not use tool or accessories if damaged, eccentric or vibrating.
Before each use, inspect accessories such as:
- abrasive wheels for chips and cracks,
- sanding pads for cracks, tear or excess wear,
- wire brushes for loose or cracked wires.
If the tool or accessory is dropped, immediately inspect for damage or change to an undamaged
accessory.
After inspecting and installing an accessory, run tool at maximum no load speed for one minute to
ensure it is properly running.
6. Always hold tool firmly, by the insulated handle or by the tip nose, so as to avoid kickbacks.
7. Never seize the chuck or accessory during operation
8. Always stop the tool before putting it down (note: Ensure that chuck is no longer rotating when
you put down the tool)
9. If the power cable is damaged, it must be replaced by the manufacturer, its after sales service or a
person with similar qualification in order to avoid any danger.