Allied Vision Bonito PRO Série Guide De Démarrage Rapide page 11

Connecting and powering the camera
Connect your Bonito PRO camera to your frame grabber via four 75Ω coaxial
cables.
Bonito PRO cameras support CXP-6 speeds only. As such, all four cables must be
connected to the camera and the frame grabber. If less than four cables are
connected, the camera will not be discovered and you may receive an error in
the GenICam browser.
Power the camera via the Hirose I/O port using a compatible power supply.
Alternatively, you can power the camera via the CoaXPress connectors with a
frame grabber that supports PoCXP. If both power options are connected,
power via the Hirose I/O port will take priority.
Hirose 12-pin connector: colors and pins for power supply
When connecting an open-ended cable to a Hirose 12-pin connector, ensure
that the pins are connected to the correct wire as described in the table below.
Note that for powering up the camera, the power connection is necessary only.
11