EGO PSA1000 Guide D'utilisation page 34

PROBLEM
Pole saw does
not cut properly.
Bar and chain
running hot and
smoking.
34
POLE SAW ATTACHMENT — PSA1000
CAUSE
◾ ◾
Insufficient chain tension.
◾ ◾
Dull chain.
◾ ◾
Chain installed backwards.
◾ ◾
Worn chain.
◾ ◾
Dry or excessively stretched
chain.
◾ ◾
Chain not in bar groove.
◾ ◾
Check chain tension for over
tightened condition.
◾ ◾
Chain oil tank is empty.
◾ ◾
Debris in guide bar groove.
SOLUTION
◾ ◾
Remove the battery pack and readjust
the chain tension, following the
section "ADJUSTING THE CHAIN
TENSION".
◾ ◾
Sharpen the chain cutters, following
the section "How to Sharpen the
Cutters".
◾ ◾
Remove the battery pack and reinstall
the saw chain, following the section
"REPLACING THE BAR AND CHAIN".
◾ ◾
Remove the battery pack and replace
the chain following the section
"REPLACING THE BAR AND CHAIN".
◾ ◾
Check the oil level. Refill the oil tank if
necessary.
◾ ◾
Remove the battery pack and reinstall
the saw chain, following the section
"REPLACING THE BAR AND CHAIN".
◾ ◾
Remove the battery pack and
re-tension the saw chain; see the
section "ADJUSTING THE CHAIN
TENSION".
◾ ◾
Filling bar and chain lubricant.
◾ ◾
Clear the debris in the groove.